Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

OT - Water leaking from battery

Posts

OT - Water leaking from battery

#1

OT - Water leaking from battery

Stephen Kirk

We just topped off a small lawn mower battery with distiller water prior to charging. We let it charge for several hours on the 12 volt 2 amp setting with no noticeable effect. So I thought it might need the 12 volt 6 amp charge setting. A short while after that the battery started to show charge, but then water leaked out of the fill caps.

Question - is water leaking from th fill caps dangerous - ie contains sulfuric acid? I put on some latex gloves prior to wiping it up, just in case. But I want to make sure the table it was sitting on doesn't need to be more thoroughly cleaned as well. The battery is sitting outside, not on charge anymore.

I'm thinking it maybe got too much water then the higher charge boiled it, but I'm not much of an expert on thes things. Plus the batteries don't actually have printed on them what they are, like 6 or 12 volt - that seems odd.

Re: OT - Water leaking from battery

#2

Jesper, Denmark

Re: OT - Water leaking from battery

Jesper, Denmark

12 volt batteries have 6 cells and 6 fill caps. The caps should be off when charging.

You probably overfilled the battery with water. The battery acid level is usually indicated with a line on the battery if you can see the level on the outside - or with a level indicator tab inside the fill holes.

The leaks do contain acid, so you caution is appropriate.

If you overfilled it, carefully pour off the excess. It's ok to pour it down a sink, just flush the sink with water afterwards.

Re: OT - Water leaking from battery

#3

answers

Bill Tindall, E.Tn.

We just topped off a small lawn mower battery with distiller water.......

What is topped off actually mean? There will be a fill line and if water is needed it should not be added above this line. More is not better. Most modern batteries now days employ some clever battery chemistry so that they don't use up water.

We let it charge for several hours on the 12 volt 2 amp setting with no noticeable effect. ...what you should have done if it is a 12 V battery.

So I thought it might need the 12 volt 6 amp charge setting....Why!?! This is a tiny battery not the honking 30 pound affair in your car. The plate area is probably at most 1/5 that in a car battery, maybe a 1/10.

In any case batteries of all kinds prefer to be charged at as low a rate as you have patience for.

A short while after that the battery started to show charge, but then water leaked out of the fill caps.....It wasn't water. It was sulfuric acid

I'm thinking it maybe got too much water then the higher charge boiled it....yes Batteries of all kinds also don't like to be charged at high temperature either. Your poor battery has suffered.

Plus the batteries don't actually have printed on them what they are, like 6 or 12 volt - that seems odd....If your's doesn't that would indeed be odd. A 6 V battery would be unhappy being charged at 12 V.

Re: OT - Water leaking from battery

#4

throwing away capacity, battery chemistry

Bill Tindall, E.Tn.

There doesn't seem to be an alternative to draining off excess liquid from an overfilled battery. One does not want it leaking onto where it sits in the machine that it powers. However, throwing away sulfuric acid is throwing away battery capacity.

In the fully charged state the lead acid battery anode is lead metal (actually a lead alloy) and the cathode is lead dioxide. The electrolyte that provides conductivity within the battery is sulfuric acid.

When the battery is starting the engine the lead metal gives up electrons and the lead combines with the sulfuric acid to become lead sulfate. These electrons flow through the starter motor and back to the battery cathode where they combine with the lead oxide and sulfuric acid to make lead sulfate and water. During charging electrons flow the other direction to return the anode to lead metal and the cathode to lead dioxide and put sulfuric acid back in the liquid.

The amount of sulfuric acid in the battery is arranged to be sufficient to make lead sulfate from the available lead and lead dioxide and have a bit left over to provide conductivity for charging. The details are unclear for all that will happen if some sulfuric acid is removed from the battery but the end result will be less battery capacity to start the engine.

Re: OT - Water leaking from battery

#5

Re: throwing away capacity, battery chemistry

Stephen Kirk

That's really interesting to learn. Batteries are one of those things I use but don't really understand all that well. It does make sense that reduction in the electrolyte, then, would reduce battery power.

Re: OT - Water leaking from battery

#6

Re: answers

Stephen Kirk

Thanks. It's good to understand some of these concepts. Yeah, seems like we charged it at too high of a setting. Now we know better. And we won't do that again.

This is a small battery, used for our electric fence. Normally the solar charger powers it, but it wasn't and we worried the solar unit was dead. I did look over it and there wasn't any sticker listing its volts/amps, which I thought was odd. Perhaps it came off outside somewhere.

I kinda figured the water was a weak sulfuric solution, but I wanted to be sure. I've got a jar of baking soda in water that I keep for cleaning up terminals and things so I'll make sure no acid solution is left around.

Re: OT - Water leaking from battery

#7

not power, capacity

Bill Tindall, E.Tn.

A battery's power is measured by how many amps it can deliver at some voltage. The number can be staggering for an automotive battery over a short time. 700 amps at 12 volts = 8400 watts! For this reason don't ever shot circuit a battery.

Capacity is a measure of how long the battery can deliver this power. The metric here is amp hours, not watts.

Re: OT - Water leaking from battery

#8

Re: OT - Water leaking from battery

BrianMonumentCO

There are two kinds of batteries that look very similar.

One is the classic car/truck battery that is used to crank the starter.

This type produces hi amperage at rated voltage but can only do it a limited number of times before it dies.

The other type is the deep cycle battery.

The DCB basically is used in motor homes and powers lights and other things.

It can be used until it is largely exhausted and then recharged.

A motor home has both types of batteries one set for the engine to start and handle vehicle type things

and the other type for the home part of the motor home powering lights and an inverter to provide 110 for refrigerator, microwave, tv, stereo and general plugs. My motor home has 8 DCB and 2 truck batteries.

The truck batteries are wired in parallel to give 12 V for much power.

Both of batteries can be obtained in forms that require replenishment of liquid.

The liquid is distilled water and you must use distilled water.

Once in the battery the water mixes with and becomes diluted sulfuric acid.

Sulfuric acid is agressive and eats clothing. When I was a kid I did model rocketry and used a used car battery to power my ignition system. Worked great. But one day I had the battery out and I held it against my pants...... No damage immediately but when it was washed it ate a hole about 10 by 10 inches.

Well that turned long pants in to shorts.

Anything that comes in contact with the batteries should be thoroughly rinsed with water.

I mean completely rinsed. Like immersion.

Starter batteries are so powerful that they can be used in some circumstances to weld.

(generally in a parallel wiring).

So don't create a short circuit.

Re: OT - Water leaking from battery

#9

pants dissolving chemistry

Bill Tindall, E.Tn.

If dilute sulfuric acid comes in contact with cotton the water can evaporate and concentrate the acid. Concentrated sulfuric acid breaks cellulose (cotton) down into glucose. When the pants are washed the glucose dissolves and a hole appears where cotton once was.

There is no difference in the chemistry of a deep cycle and regular car battery. However, the details of how the anodes and cathodes are constructed do differ. A starting battery will have low internal resistance to provide high starting amps. A deep cycle battery is less concerned about high current and more concerned about avoiding internal shorts.

Re: OT - Water leaking from battery

#10

why modern batteries typically don't need water

Bill Tindall, E.Tn.

In days gone by the battery was charged by sufficient voltage to not only turn the lead sulfate into lead and lead dioxide but also to split water into oxygen and hydrogen, which made the water go away. For this reason sparks around a charging battery could cause it to blow up from the hydrogen ignition. And, the battery needed the water replenished now and then.

Modern cars have more intelligent voltage regulation of the charging. And, additives like calcium are added to the lead that make splitting water into hydrogen and oxygen more difficult(it requires higher voltage to break water at these modified electrodes). As a result the battery can be largely sealed so that water is not lost by evaporation either.

Re: OT - Water leaking from battery

#11

Ha!  Same thing...

Tony - Memphis

I returned a battery to Sears one morning on the way to work. Couple of weeks later, I washed the coat I wore that day....lots of little white spots and a few little holes. Now a yard jacket.

Tony

Re: OT - Water leaking from battery

#12

Re: You are correct Bill ~but

Larry Clinton At Frankfort, (Central) Indiana

I have found that I can extend battery life of the "sealed" batteries by removing the "caps" (they don't look like they are removable but almost every one I have looked at does have removable / replaceable caps) and filling the battery cells up after a couple years of service (with distilled water). The sealed versions do seem to have some extra water/acid capacity so may not do much good but seems to work for me.

I live in Frankfort Indiana, we had an large Exide battery plant for several years. My late brother was a Superintendent at the manufacturing facility, youngest son worked there for a time. I have toured the plant a couple times. It was pretty interesting.

Re: OT - Water leaking from battery

#13

Jason Roehl in Lafayette, IN

Right.

Jason Roehl in Lafayette, IN

"Sealed" with regards to most automotive batteries means simply, "not vented", not "unable to open without destroying the case".

I've found that pulling the caps is indispensable to troubleshooting a battery, as you can measure the voltage between adjacent pairs of cells, and if one voltage is lower than the others (or lower than about 2.05V), the battery has internal problems. If it's zero volts between two cells, there's an internal shorts. You measure by simply sticking the voltmeter leads down into the acid (take necessary personal protection precautions, of course).

Jason