Temptation
Mark Mandell - Gone Round In New Jersey
Had a piece of alleged "studio" furniture, a dining room table represented to be QSWO, dropped on my by one of my kids with the idea of making it useful.
Yes, I can make legs to match the two (2 missing) that came with it.
Yes, I can trim off the shop-worn corners of the 1" top to take out those dents, dings, and crunched corners., but the table's gonna be an inch or so shorter.
Yes, I can refinish the piece after I sand out "most" of the dents and dings in the top.
So it's for my kid, right? I should make it look like she wanted it to look. After all, I'm DAD THE MAGICIAN, right? 
So I got most everything done, fabricated, sanded, sealed, ready for the topcoats. When I notice that both halves of the top are bowed by a good 1/4" . . .
Only 1 board in 3 is actually QS and it appears that this studio person was using the extension slides to pull the top down to a facsimile of flat.
It's for my kid.
I'm tempted to saw the top apart then rejoint and reglue it so it's actually flat.
Tempted, mind you. Not committed. It's not, after all, my work. I didn't make it.
It's NOT MY FAULT!!
Sheesh



