Half Round Table - Edge Profile
Joe in a Cleveland suburb
One of my Goldens kicked me out of bed early this morning so I was able to get an early start on the little table's top.
I made a tramel out of scrap and drew the shape on the glued up panel (about 10-1/2" radius), then simply cut to the line on the band saw.
Then the fun started - shaping the edge profile. I decided to use various hand tools to shape the edge opposed to messing with a router and so on. It was pretty simple and didn't take very long. Plus I had done it this way before and knew what to expect. I used, depending on the grain, a block plane, card scraper, #51, and a scratch block thingy I made some time ago. Overall the 51 and block plane worked best.
The tools I used:
#1
Using my scratch stock thing. Sometimes I pulled. Somtimes pushed.
#2
#3
Using the trusty old #51. Sometimes pulled. Sometimes pushed.
#4
#5
#6
Using the block plane
#7
The profile starting to take shape.
#8
The profile pretty much done. One last little hit with some 220 and it all looked good. In fact, I started to put some finish on it tonight. The end is in sight.
#9
#10
Thanks for looking.




