Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Half Round Table - having some fun

Posts

Half Round Table - having some fun

#1

Half Round Table - having some fun

Joe in a Cleveland suburb

Over the weekend I glued up three panels that will become the half round'ish top.

I took one board and cut out three sections that looked best (to me). Flattened one side of each with hand planes and jointed the edges with a plane. Used the (power) planer to bring them down close to final thickness. Glued'em up.

Took the glued up panel out of the clamps, scraped off some glue dribbles, and began to plane it a little using a smoothing plane. That was fun. The plane was working perfectly and I was getting super thin shavings with no tear out and very little effort. It felt as if I was planing butter. I had to make myself quit or else the top would become too thin...

I was using winding sticks and a straightedge to gauge/watch my progress. I still have to do the same to the top (show side) of the glued up panel. So far, I was only working on the bottom to practice planing and setting up/tuning up the smoothing plane.

Next I need to cut it into the half round shape. I'll use the bandsaw. I'm not sure If I'll just draw the shape on and cut it, or use a board with a pin to rotate on.

After I cut it, I'll likely use a scratch block to put a small half round profile on the edge of the table top. I did this with a couple Shaker round tables in the past and it worked well. Not sure how it will do on the curly maple though. I'll have to test it out.

Thanks for reading/looking.

This crappy iPad picture doesn't do the curly maple justice...


Re: Half Round Table - having some fun

#2

thanks for the post, a finishing problem

Bill Tindall, E.Tn.

Good to see progress being made. I wish others would take the time to post progress on their projects.

The maple top and cherry bottom lead to a finishing challenge which may result in finishing them separately. Curly maple would traditionally be stained a yellowish tint and oiled to bring out the curl, then varnished or shellaced. However, this finish may not look attractive next to traditionally finished cherry. If you want to keep the maple white(it is going to turn light brown no matter what you do) then it must be finished with a non-yellowing finish. The cherry, on the other hand, would benefit from a yellowing finish, or at least oiling, which will yellow.

Re: Half Round Table - having some fun

#3

Re: thanks for the post, a finishing problem

Joe in a Cleveland suburb

Thanks Bill.

I've used maple, curly maple, and birds eye maple in the past on other projects such as end tables, coffee tables and the like.

I expect (and don't mind) it to yellow over time. I actually like it to look older over time. In the past I've used TransTint dyes, then BLO to 'pop' the grain. I think it was Early American Maple diluted. This was based on a FWW article by Jeff Jewitt years ago.

For this top I will likely just apply numerous coats of BLO until it seems to not take anymore in. Then varnish of some sort. My wife doesn't want it dyed at all anyway.

The base will get some BLO (already started doing that) then wipe on some varnish. I'm not a fan of coloring Cherry. I like to watch it change its own color over time. I find if I sand it well enough, blotching isn't a big problem either. Although, a little blotching with cherry isn't a problem in my eyes either.

Anyway, I have some cut-offs of the maple and will try a couple things on it first. Maybe I'll change my mind about the dye...

Thank you.