Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Needing some more help

Posts

Needing some more help

#1

Needing some more help

Marty

In restoring a old desk that sat under water for 10 days after Katrina, the drawers need replacing. I purchased a Half-Blind Dove Tail jig to accomplish this task. The side of the drawers are 3/8 and the front 3/4. Question. Should I cut the Dovetails in the 3/4 inch material and then cut down to the 3/8, or cut the sides to the 3/8 and then do the dove tails? My thought is if the material is thinner it might not be a clean dovetail? I have the Keller Jig, but it's for through DT, never have done Half-blind DT's I am at a questioning point. Thanks, Marty

Re: Needing some more help

#2

various alternatives

Bill Tindall, E.Tn.

If you own a Keller (wonderful invention) you could dovetail a 3/8" box and then apply a front to it.

Or, I have never had a problem dovetailing a thin drawer side to a 3/4" drawer front.

Re: Needing some more help

#3

Re: Needing some more help

Dick Coers

You will need to dovetail thicker stock and thin it after. I would be concerned about how that will work. The cuts in the front will still have that radius from the router bit, the sides won't. You'll have to round the back side of the tails if you don't want to see the radius in the fronts. It would take some experimentation to prove the concept. I've done half blind with the Keller, by using a thinner drawer front, cutting the dovetails, then glueing on an 1/8" thick piece of solid stock to the front. I oversize that 1/8" piece, glue it on, then flush trim it to the existing front. If you resaw that thick veneer off the drawer front before dovetailing, it will be nearly invisible after being glued back on.