Markal welder's pencil for walnut
Orinda Dan
I am starting a project using walnut and found the Pilot P500 gel pens that I normally use for marking dark woods stopped writing after just light usage. I pulled out several new ones and they all gave out after a short time. I started looking for an alternative and came across the Silver-Streak welder's pencil made by Markal.
While the marks are not quite as visible as a new gel pen, it is more than adequate and can be easily sharpened by an electric pencil sharpener. I have attached a picture showing the points after sharpening in an electric pencil sharpener of the welder's pencil (left) compared with a #2 pencil (center), and a yellow artist pencil (right) that I also tried.

The next picture shows various writing instruments on black walnut:
1=new gel pen, 2=gel pen after light usage, 3=welder's pencil, 4=#2 pencil, 5=yellow artist pencil.
As evident, the welder's pencil was easily visible and approached the legibility of a new gel pen.

The last picture shows a mortise marked with the welder's pencil on 3.75x3.75" thick leg stock. The walnut is from a different batch than the above picture and is lighter in color. There is less contrast between this walnut and the pencil marks, but the marks are still quite workable. I am using a slot mortiser for the mortises, and using the welder's pencil made setting up the machine quite easy.

These pencils are also inexpensive, and a box of 12 costs less than $9 on the Staples website. I hope they will be around for a long time.
Dan


Here we would use power shapening, with dust collection of course.






