Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

stack cutting

Posts

stack cutting

#1

stack cutting

Jack Putnam

I would like to know if there is a better way to do stack cutting. I have a pattern glued down to two pieces of 1/8 inch birch plywood. I have put nails into the outside edge of the two boards one on top of the other and a nail in the center of the pattern to hold it together better. As I drill a hole through the two boards I put more pressure down with my hands so the two boards won't separate from each other.

Well I found out that it didn't help at all. I now have tear out between the two boards and the pattern is shot. I have no problem with just doing one board at a time but I wanted it to go a little faster. I have even tried to glue the outside edges together but that didn't work either. Thanks for any help you can give me. Desperate.

Re: stack cutting

#2

Re: stack cutting

Ron in Sterling, CT

Jack,

I use Scotch brand 2 sided tape between my pieces and haven't had any problems with tear out when drilling holes. This tape is thinner than regular 2 sided tape, yet holds well for me.

Ron

Re: stack cutting

#3

Re: stack cutting

William Duffield

Stick everything together with 3M 77 spray adhesive. Coat both contact surfaces at all the places you are going to cut. Use a J-roller to make sure you have a good bond. When you've finished cutting everything out, release the spray adhesive by applying lacquer thinner to all the joints.

Re: stack cutting

#4

You are not making your needs very clear.

Keith Newton

I find it both annoying when someone only gives one dimension 1/8" here, when I'm sure there must be a couple more, or maybe my crystal ball needs repair.

Vacuum, is a great way to quickly hold a piece to a template. Even if you don't have a vacuum pump , a shop vac will give ~1 psi, which would be 100# for a 10"x 10" opening in the template.

If the edges have been sprayed with contact, this adds to anti-skidding, so picking up a part is just the on off switch on the shop-vac.

I think Ellis may have added one of my post on this in the articles, so you may search with my name, and shop-vac router template, to get some ideas.

Re: stack cutting

#5

Re: You are not making your needs very clear.

don stephan

the sawing method will affect splintering. A portable jig saw with an up and down motion will flex plywood only 1/8" thick and would seem likely to cause tear out, especially if a coarser/duller blade used. A fine tooth blade in a band saw wouldn't seem likely to cause tear out between the sheets. Same with a fine tooth and slow feed rate in a stationary jig saw.