Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Shiplapped Boards

Posts

Shiplapped Boards

#1

Shiplapped Boards

Steve Kirincich

Hello,

I am nearing the completion of a chest with a bottom made of shiplapped boards which are held in a dado cut into the inside faces of the chest sides with my old plow plane. The shiplap boards are supposed to handle seasonal expansion and contraction, but I assume that this is only true when the overlapping board edges are cut such that there is some play in the fit. It would seem that the nature of the joint allows for a loose board-to-board connection without creating a gap which extends from the inside to the outside of the chest. Your thoughts would be appreciated. Thanks.

Steve

Re: Shiplapped Boards

#2

Re: Shiplapped Boards

John McGaw

Yes, you need a gap between the boards to accommodate seasonal movements. One key point to remember is that the board are not literally unfastened. In a wide span of boards you need to secure the outside edges of the outside two boards and then the middle of each of the others -- I usually use a 16-gauge brad for the purpose since there is no real load involved. Fastening this way each of the boards can expand and contract but they cannot, en masse, all shift in such a way as to open a complete gap. In applications such as the bottom of a blanket box I'll rest the boards on narrow battens around the bottom, secure them at the proper spacing, and then apply a bit of moulding around the inside to hold the boards down and minimize cupping (as well as covering the raw ends) and the moulding can be easily removed later if a board needs to be replaced.