I'm not sure how many of you start your projects by harvesting a tree, instead of buying lumber. A little over a week ago, over on the turning side, I described how I loaded a 20" Walnut log 10' long, without the aid of loading equipment, but my method is not nearly as easy as Richards method. he he
Too bad you didn't get a video of your method. While the youtube fail is entertaining (but predictable, mostly), yours would have been very educational.
I'm surprised his pickup still rolled after loading. I guess he still had a shot at getting it home, but I don't know how he was going to unload it.
Re: Harvesting and loading trees the easy way. *LINK*
Yea man, and he didn't waste any good wood by cutting a hinge notch. It landed right where he intended. ha
I wish I could have seen a license plate or something to indicate where this was. The woman walling Richarararararddd at the end, sounded like it could have been someone from around pretty near here.
You have to hand it to him though. The end of that log looked a lot better than the side of the tree, just a few feet up. That hubcap blowing off was a nice touch.
I've been wondering. Nobody would consider that a good saw-log, and why cut it that way if it were for firewood, so he has to be a turner. ha. I think it would be fun if someone could identify him as such. I'd love to see his turning.
Re: Harvesting and loading trees the easy way. *LINK*
I'm amazed he didn't trap his saw. No visible hearing or eye protection, shirt flapping out.
I'm a bit skeptical, though, about one thing: I watched it a couple of times, hoping to figure out how long the chainsaw bar was, because he was also cutting off the top of the bar when he did the far side of the cut, a bad practice for a bar of any length to speak of, and that part is fuzzed out. I'm wondering if it wasn't some kind of setup/fake.
Re: Harvesting and loading trees the easy way. *LINK*