Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Ram type radial drill press

Posts

Ram type radial drill press

#1

Ram type radial drill press

Pete

I just got a Delta Rockwell 15-120 radial drill press and have some "pressing questions'.

I had to take it apart to get it home and before I put it together I would like to clean and lube the moving parts.

What should I use to lube the column and the jackscrew that makes it go up and down?

One of the bearings in the cradle was broken (the outer race was broken in two) so I am going to replace all 8 while I have it apart. The remaining seven bearings appear to be dry. Does anyone know the procedure to adjust them in order to take out the play and to keep the arm parallel to the table? Should I lube the ways on the arm or should they stay dry?

Re: Ram type radial drill press

#2

If you haven't found OWWM, you need to now


Re: Ram type radial drill press

#3

check here

del schisler

http://www.mikestools.com/Delta-Drill-Press-Parts-Lists_2282.aspx

Re: Ram type radial drill press

#4

Re: Ram type radial drill press

Grant in Iowa

Pete,

If it is built like their radial arm saws of the same period, there are a number of bearings that ride on a machined track. You will find that these bearings are mounted on eccentric shafts that allow adjustment. To remove or adjust them you first loosen an Allen set screw, then adjust by turning a screw on the end of the shaft. Being an eccentric shaft, be careful not to apply too much pressure or you can break the outer race of the bearing (don't ask me how I know that!).

You may find that some of the bearings are in a fixed position, while others are adjustable. Use the adjustable ones to both align and adjust play in the slide arm.

FWIW,

Grant in Iowa