Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

OT - recaulking a building - getting up the sides?

Posts

OT - recaulking a building - getting up the sides?

#1

JL

OT - recaulking a building - getting up the sides?

JL

Between building sets and doing signs - I do maintenance on the playhouse.

Anyway the construction is tilt slab. The seams are caulked. I would really like to recaulk the outside. Well in the back it is ~40' or more from the ground. In the front it is on the order of 20'+.

I have no problem w/ scaffolding - except on the sides where the ground is sloping a bit much. I could put leg extensions on the scaffolding. It would be a lot of work.

I've been on boom lifts and I don't think much of their stability at the higher reaches. Any other suggestions?

Re: OT - recaulking a building - getting up the sides?

#2

Jason Roehl in Lafayette, IN

I don't get it.

Jason Roehl in Lafayette, IN

There are two reasons I don't use boom lifts more often: access and cost. Otherwise, they're one of the safest ways to get a lot of work done up high in my experience. I had an 80' boom lift up to about 65-70', at least 40' above the roof of the building I was working on, on a somewhat windy day (10-20 MPH winds). It swayed, but I wasn't at all concerned it would go over. I would have taken it all the way up, but I didn't realize the boom had to be near or fully vertical before the bottom section would extend. (One of these: http://www.whellock.com/product_data/jlg_800a/image.jpg ) These things are HEAVY--the 800A is over 34,000 lbs, a 60' boom is about 24,000 lbs, and a lot of that weight is in the base. They also typically have tilt alarms and safeties built in. They're pretty safe, especially if you're operating a ways below the capability limits.

Anyway, by access, I mean that often there is no way to get a boom lift around a house or building because of landscaping, soft ground, tight clearance to other buildings, etc. If those conditions aren't present, then cost is the deciding factor. A typical delivery/pick-up fee is about $300-400 around here, plus the daily/weekly/monthly rental. On small jobs, it's probably not worth it, but if it's a large job with lots of high work or difficult-to-reach features, then it's a no-brainer. Setting up scaffolding is time-consuming and physically demanding.

Jason

Re: OT - recaulking a building - getting up the sides?

#3

JL

Re: I don't get it.

JL

I see - the one I was using wasn't near as hefty. It was what they called a "tow behind. You had to put down the outrigger pads and everything.

Re: OT - recaulking a building - getting up the sides?

#4

Bosun's chair?


Re: OT - recaulking a building - getting up the sides?

#5

Re: OT - recaulking a building - getting up the si

Bruce, a MN Galoot

Call your local utility and see if they will donate time on their bucket truck. The larger ones can reach at least 40' and carry loads substantially greater than anything you could require.

Re: OT - recaulking a building - getting up the sides?

#6

Jason Roehl in Lafayette, IN

Re: I don't get it.

Jason Roehl in Lafayette, IN

I've used several of those as well. In general, they weren't good for a lateral reach and they were very sensitive to being out of level, but you can get them to reach 40' no problem. Boom lifts on the other hand can often be extended fully (or most of the way) in a horizontal direction and sweep from there to a vertical position. I've been at full extension in a 66' boom with a partner, painting windows on a 3.5-story building's alley side--in which the lift itself didn't fit.

If you can park a lift at the top of the hill for the sides of the building, a big enough lift will reach the 40' height no problem, depending on the horizontal distance from the top of the hill to the peak height. The right lift can be quite useful, but they universally don't like hills.

Jason

Re: OT - recaulking a building - getting up the sides?

#7

My experiences...in tree access *LINK*

Tom Dunlap

For 3.5 years I worked as the arborist on a small college campus. We had a JLG 65. It worked really well for taking care of the trees. I was very sensitive to keeping the unit far away from the root plate so that I didn't compact the soil. The side reach at low angle was amazing! For many configurations I was able to drive the unit without booming in. I used it straight out and even some times below horizontal too.

This was a very useful vehicle and saved me a lot of energy. Working in 100* plus days for weeks on end is draining.

Tom


JLG 65

Re: OT - recaulking a building - getting up the sides?

#8

Re: OT - recaulking a building - getting up the si

michaeljurnigan

I am a JLG certified instructor. Aerial Work Platforms are totally safe if operated in accordance with the operator's manual which is required by OSHA regulations to to be on all units at all times and in good condition. One of the main concerns is to make sure the ground will support the weight of the unit without giving way. As previously noted they are heavy. Also perform the per-operation checks from the ground station as mandated in the operator's manual. Also they require a level spot to be operated from; within 5 degrees of level. I have operated up to the 150 foot model to full extension. I do not recommend traveling with the boom extended and elevated as previously stated. I recommend swinging back to the travel position and booming down. If you are operating an articulated arm model ( such as the pull behind model) the main or lower boom arm must be raised to the vertical position before raising the auxiliary boom. If you do not, it puts the unit in an unstable position. Also if you operate an AWP always wear a harness with a short lanyard. Most people think the harness is for fall protection, it is not. That is the purpose of the basket. The harness is your "seat belt" to keep you from being ejected. Never ever climb on the rail to extend your reach and never use a ladder or a plank across the rails to extend your reach. Almost all accidents occur because of operator error. Do not operate within 10 feet of power entrance cables or overhead wires. Remember what Norm says about reading and understanding the operator's. In this case it will save your life.

Mike now from Zuni, VA