variable vice workbench
John Lucas
I have a lot of vices that I use occasionally but not all the time. I used to have them screwed to boards that were clamped in my woodworking vice when I needed them. This was OK but never optimal. I needed to move a workbench and decided to modify it and make it an outfeed table for the table saw. I cut a large dovetail in the top and made dovetail pieces to hold the vices + one blank one to fill the space when the vices aren't needed.
I still have to finish the parts that hold the dovetails in place. It's 2 all thread screws that will have have copper caps on the end. They will screw up at an angle through the bottom and push the dovetail pieces back deeper into the dovetail. I've made the bracket but didn't have any knobs to fit the all thread so I'll pick those up tomorrow.
I need to make one more insert for my carving stand.



