Mystery Tool Contest
Mark Mandell - Gone Round In New Jersey
OK Tool Junkies . . .
This was the 4th weekend of trying to go through my departed father-in-law's stash of tools and hardware (he was a Master Plumber, then an engineer, and finally a hobby woodworker, but always a consummate "never throw away what you might need later" guy) to prepare for the estate auction for the stuff that nobody in the family either wants or has a ready buyer. Then came up the obligatory antique tool chest with various pieces of rusted flotsam that included no-name planes, brace & auger bit sets, ball-peen and forging hammers, cold chisels, and arcane wrench-type things that only fit objects that haven't been made in 60 years.
Fortunately I was wearing gloves when pulling stuff out as I'd have been down at the ER getting a tetanus booster if I'd grabbed the pictured gems.
So, WT..... are this things? They are hand forged and the points and edges, while rusty, are knife-sharp.



PS: These are small hand-tool items with the "blades" 3-4" long.

), he would probably be using the more technologically complex versions. David's idea that they are for chairs is plausible, on the surface, but the taper angles of the ones you have are greater than chair reamers. They would probably be used for bungs made from cork, or other cork-like material that is more compressible than the hard woods usually used in chair joints. Other bung hole reamers for wooden bungs would have a smaller angles.


