Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Scribing to Walls

Posts

Scribing to Walls

#1

Scribing to Walls

don stephan

Fortunately I only have to scribe items to walls every few years. An Accuscribe tool works well for me except that the pencil point quickly dulls, leaving a broad line. A .5mm mechanical pencil wouldn't fit the Accuscribe without trying to drill it larger. How do those who scribe all the time keep a fine pencil line?

Re: Scribing to Walls

#2

Sandpaper or a chisel

John in NM

My scribing tool is homemade, so it depends on a snug fit to hold the pencil. Have to sharpen without removing it as much as possible, so I usually use a sharp chisel. Some 150 grit paper might do it as well, but not as fast.

I've never been so good at scribing, so a fat line doesn't bother me much. I'm not likely to get so tight a scribe that a few tenths of mm matter much :D

Re: Scribing to Walls

#3

Re: Scribing to Walls

Barry Irby

I don't know what an Accuscribe Is.

What I do is put the material close to the wall, lay a washer on it, put a pencil in the hole and role the washer alone the wall with the pencil, drawing a line on the material. Most of the time I use a belt sander with a 36 grit belt to sand to the line or parallel to the line. Since the washer controls the inside edge of the line, I sand to that, leaving the line, no matter how wide it is on the material. If the fit is close to start with, I just stand the pencil up on the wall and slide it alone the wall.

(Then I use one inch caulking ;) )

Re: Scribing to Walls

#4

Re: Scribing to Walls

Tom Dunlap

Can you change out the pencil for a scribe point? Think of a device like dividers rather than a compass.

Scratch a line instead of drawing one.

Tom

Re: Scribing to Walls

#5

Re: Scribing to Walls

BrianMonumentCO

One question is how do you sharpen your pencil?

If you use a round sharpener it will of course become a coarse pencil ie broad line.

If you sharpen it like wedge with one or more flat sides/faces then it will maintain a sharper line longer.

It will of course become dull but the flat side will still be in the same place.

Re: Scribing to Walls

#6

Re: Scribing to Walls

Keith Newton

Don, you don't tell what you are scribing to, but it looks like that thing would be a bit bulky trying to fit something up to a highly textured rock fireplace.

I normally just use a thin strip of wood, with a hole or notch cut into it, with the pointy end rubbing the target surface, and the pencil pushing down in the hole or notch along the edge.

Like brian, I always sharpen any pencil with a double taper wedge. #2 pencils are too soft for woodworking, so look for 2.5 hardness, and buy a box when you find them. My laminate and cabinet hardware supplier always has a box with their contact info on it, sitting on their counter for their customers, so I grab a handful every time I'm in there.

Re: Scribing to Walls

#7

Re: Scribing to Walls

don stephan

Some very helpful replies here, thanks!

Re: Scribing to Walls

#8

Re: Scribing to Walls *LINK*

Bill Houghton, Sebastopol, CA

I haven't had trouble with the pencil wearing too fast. I use General Tool's little pencil compass, see link below. Fits into just about any spot, cheap, precise.


http://www.generaltools.com/842--Precision-Pencil-Compass_p_251.html

Re: Scribing to Walls

#9

Buy a harder pencil

Dick Coers

A #2 pencil is rated at a hardness of HB. There are 9 harder grades with 9H being the hardest. Places like Michaels sell them in the artist section.

Re: Scribing to Walls

#10

Re: This is an Accuscribe *LINK*

William Duffield

It's made by FastCap.

A couple of the older one- and two-star ratings are moot, as the design has been corrected. If you don't like ordering from Amazon, Woodcraft also carries it, but at full retail.

To answer concerns of some other responders, FWIW, it has a built-in pencil sharpener.


http://www.amazon.com/dp/B0001GUDT6/?tag=googhydr-20&hvadid=36162650200&hvpos=1t1&hvexid=&hvnetw=g&hvrand=18203008812919823600&hvpone=&hvptwo=&hvqmt=b&hvdev=c&ref=pd_sl_1rhs774ao0_b