Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Follow-up to Grizzly OSS problem

Posts

Follow-up to Grizzly OSS problem

#1

Follow-up to Grizzly OSS problem

Paul Blackwell

I tried Grizzly's tech support suggestion to try removing some rubber by applying sandpaper to a turning spindle and then using baby powder. No luck again. I was skeptical about the freezer method, but put the rubber cylinder in the freezer overnight. This morning I took it out, applied baby powder and voila, it slipped right on. Thanks to all for the suggestions.

Re: Follow-up to Grizzly OSS problem

#2

Re: Follow-up to Grizzly OSS problem

del schisler

wont the rubber sweat when it warm's up , and than the powder get messy ? just a thought , sound's like the rubber clinder is to big, if you had a leath you could turn it down smaller ? i had the ridgid spindle sander with no problum's , i belive i would ask for replacement on the rubber drum ? also i loosen the nut on top as to not keep it in tenion