Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Any electronics experts know what this is?

Posts

Any electronics experts know what this is?

#1

Kneale Brownson

Any electronics experts know what this is?

Kneale Brownson

The black bit on this board, part of the controls for a knitting machine motor, blew up and let all the smoke out. Anyone know what it is and where I might find one? It has two pins through the board. I can replace it if I can find it.


img

Re: Any electronics experts know what this is?

#2

Re: Any electronics experts know what this is?

CJ in MPLS

It looks to be an electrolytic capacitor having a 0.1 microFarad value. Whether you need an electrolytic capacitor or simply one that is 0.1 microFarads is a question I cannot answer, but I'm guessing any old 0.1 mF capacitor would work.

CJ

Re: Any electronics experts know what this is?

#3

Hey! Watch your mouth.....

Barry Irby

You can't be saying mF here, this is a family forum. Even if its a .01mF, I'm tellin what you said.

and, By the way, without that your device will start Side Bumbling.

Re: Any electronics experts know what this is?

#5

Jason Roehl in Lafayette, IN

For the record...

Jason Roehl in Lafayette, IN

When typing the abbreviation for "microfarad", if you aren't into finding the ASCII code to form the Greek letter µ ("mu"--can be made by holding the ALT key while typing 230 on your number pad), it's commonly accepted to type a 'u' instead, so you would abbreviate it "uF".

Jason

Re: Any electronics experts know what this is?

#6

Re: Any electronics experts know what this is?

Bob Entwisle in NJ

That is a non-polarized, 0.1 uF (micro Farrad), 250 Volt AC, -40° to 100°C, Capacitor, with an X application rating which means it's approved/tested for use across the AC line.

Re: Any electronics experts know what this is?

#7

Re: Any electronics experts know what this is?

Chuck in Mtl.

you might find the part online or near you if there are any electronic parts stores.

Re: Any electronics experts know what this is?

#8

Re: Any electronics experts know what this is?

J. Waters

Isn't this usually called a "safety" cap? If it's an x?

I'll look for a link.

I think there is probably more than that wrong.

Re: Any electronics experts know what this is?

#9

Re: Any electronics experts know what this is?

J. Waters

Here is the link I was thinking of

http://www.justradios.com/Y2capacitors.html

Re: Any electronics experts know what this is?

#10

Re: Any electronics experts know what this is?

J. Waters

http://www.justradios.com/safetytips.html

This one too.

Re: Any electronics experts know what this is?

#11

Re: Any electronics experts know what this is?

Ralph Lipeles

There's one that looks very similar on eBay. Search under the specifics, Capacitor, .1MF , 250V.

Re: Any electronics experts know what this is?

#12

In days of olde

Bill Howatt

The capacitors on the 120V AC line input were paper but somewhat unique in that they had a 600V rating which was higher than any others in the radio.

I used to work on many of these old tube radios along with old tube TVs and never came across one that had failed.

Bill

Re: Any electronics experts know what this is?

#13

Re: Any electronics experts know what this is?

del schisler

it is a Capacitor the value is a .1 mfd. 250 volt. you could get it maybe at any good radio and tv repair , maybe radio shack ? Look and see if the leed's of the cap. are soldered across the ac line comming into the unit,? Those are for spike's on the line and also cut down any osc. comming out of the unit . Does the unit still work ?? if so just get a .1 mfd @250 volt or higher voltage and solder it in, it doesn't matter which way it goes , it isn't marked plus or minius . good luck i was in repair for 50 yrs or so retired now

Re: Any electronics experts know what this is?

#14

Kneale Brownson

Yup, soldered into part of power supply

Kneale Brownson

The motor stopped when it started smoking. We did find where another part of the mechanicals had rubbed a wire bare elsewhere in the controls for the machine. Will address that before reusing. No real electronics stores anywhere near our present location.

Re: Any electronics experts know what this is?

#15

this will work for you

del schisler

here is a cap that will work ever tho the voltage is higher that doesn't make a difference, the link

http://www.ebay.com/itm/Black-Cat-PKM10P1-1-MFD-1000V-Capacitor-PKM-10P1-/140595514329?pt=LH_DefaultDomain_0&hash=item20bc254bd9

Re: Any electronics experts know what this is?

#16

Danger, Will Robinson!

John McGaw

The capacitor you called out is rated at 1000VDC while the failed capacitor is rated at 250VAC. While having a higher voltage rating is usually a good thing, the physical characteristics of DC and AC caps are very different and the AC units are able to put up with more abuse that being connected across the mains causes. The general rule is that never the twain shall meet.

Re: Any electronics experts know what this is?

#17

Re: I agree

Ed Wozniak-Buffalo, NY

Believe it or not capacitors have current ratings as well as voltage ratings. When a capacitor is connected across an AC voltage source, like an AC power line, current will flow through the capacitor. The ~ symbol next to the 250 V marking on the part indicates that the part has an AC rating and can handle the resulting current that flows when it is connected across a 250 VAC line. The 1000 Volt part suggested may work but then again it may not.

Also not all capacitors fail in the same way. Your capacitor blew up but nothing else caught on fire. Some capacitors can fail in a way that they will cause them to continuously generate heat and potentially cause a fire. It is best to try to find a capacitor that is specifically intended to be connected across an AC line.