Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Half round table - a little progress

Posts

Half round table - a little progress

#1

Half round table - a little progress

Joe in a Cleveland suburb

So after the discussion last week, I decided not to do the DT and I'm just doing a regular bridle joint.

Here I've laid it out on the apron.


Getting ready to cut the mortise



Getting ready to mark out the tenon



Now all I have to do it cut it out. If I'm right, all I have to do is cut it out and then plane the leg to fit. The mortise should be a hair tight so that plaing the leg and sneaking up on the fit will give me a nice tight fit.

That's the plan anyway. I may end up with a nice curved piece of fire wood...

Thanks for looking (and all the help so far).

Re: Half round table - a little progress

#2

Looking really good Joe

John in NM

I bet it goes fine :D

I have a similar tenon jig, it never occurred to me to swing the screw arm down like that! I wonder now if I ever read the directions..... :D :D :D

Re: Half round table - a little progress

#3

Directions?

Joe in a Cleveland suburb

Thanks John.

Directions? I don't understand. What's that? :b

Re: Half round table - a little progress

#4

You know, North, South...


Re: Half round table - a little progress

#5

Re: Half round table - a little progress

Jesse Cloud

Looking good!

That's gonna be a sweet table!