Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Nails (video) *LINK*

Posts

Re: Nails (video) *LINK*

#2

Bill Blasic

Re: Nails (video)

Bill Blasic

Enjoyed that, pretty awesome short film.

Re: Nails (video) *LINK*

#4

Thanks Steve

Keith Newton

My Granddad was a blacksmith/ farmer, and I have some of his tools. I keep threatening to set up a space around my shop dedicated to that, but usually just use a torch and his old anvil for my needs.

I have a box of cut nail from around that time that I've gained a new perspective of.

Re: Nails (video) *LINK*

#5

Thanks!


Re: Nails (video) *LINK*

#6

Re: Nails (video)

Dick Coers

Thanks Steve, great movie. We have a local steel and wire mill in Bartonville, IL and I toured it as a kid in 4-H. I'll never forget that place with red hot steel wire slinging around and the noise of the nail machines. I doubt if they are still making nails, but I know they are making wire and wire panels still.

Re: Nails (video) *LINK*

#7

Another one - the chairmaker and the boys (video) *LINK*

GolfSteve in Calgary

Not as good as the nails video - but more direct woodworking clips, including some tips on making Shaker chairs.

Grandpa saves his own skin at 19:15 by not letting Mom know what happened in the shop!

https://www.nfb.ca/film/chairmaker_and_the_boys


The chairmaker and the boys

Re: Nails (video) *LINK*

#8

Re: Nails (video)

Bruce, a MN Galoot

That was great! I didn't know anything about either process, and while it certainly may seem more romantic (or whatever) to have hand-made cut nails, they were certainly a lot of work. It was still probably better than the poor schmuck whose job it was to flip that steel blank from side to side all day.

I recall a passage from one of the Laura Ingalls Wilder books in which the kids would go in search of a nail that went flying off after a misplaced hammer blow, and now that makes a lot more sense, given the hand labor that went into their making.

Re: Nails (video) *LINK*

#9

Interesting video and coincedently

Mark Hennebury

Nice videos,

Always something interesting in old videos , it's nice to see how things were done and get to learn a few things. Thanks for posting them.

As a bit of a coincidence:

I maybe making some wooden gear teeth for an old flour mill similar to the gears in the chair-shop video; the teeth are fitted and wedged into the openings on the cast iron wheel of the vertical shaft, they mesh with the cast ironteeth on the horizontal shaft. I made some similar a long time ago, and was just asked to quote on this job.



" border="0" alt="">

" border="0" alt="">

Re: Nails (video) *LINK*

#10

Re: Nails (video)

William Duffield, on the Cohansey

The nomenclature needs a little clarification. The nails hammered out individually by the blacksmith are "forged" nails, while those that are being sheared from flat stock while the guy flips them over and over are "cut" nails.