Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Watco vs Deft Danish Oil

Posts

Watco vs Deft Danish Oil

#1

Watco vs Deft Danish Oil

Randy Stukenberg

Is there much difference between the quality of finish between Watco Danish oil and Deft Danish oil? I see on the can that you can finish Deft with water based finishes, but Watco only mentions oil based poly after 72 hours. Any preferences?

I am using it on a bathroom vanity with crotch figure walnut panels in the doors and side and want the Danish oil to make the figure "pop."

Thanks!

Re: Watco vs Deft Danish Oil

#2

Re: Watco vs Deft Danish Oil

Steve Schoene

I can't imagine you would notice any difference. Either, could be coated with waterborne finishes after being allowed to cure adequately. (several days with temps in the 70s.) For perfect certainty use a coat of dewaxed shellac before overcoating. Zinnsser Seal Coat will work, or mix dewaxed flakes.

Re: Watco vs Deft Danish Oil

#3

Re: Watco vs Deft Danish Oil

don stephan

I've often read that boiled linseed oil is what makes grain and figure "pop", and it is only a small percentage of commercial danish oil. You might experiment with just blo to see if results sufficient. After blo fully cured, it probably could be topped with just about anything, but e ven one coat of dewaxed shellac is a safe tie coat. Again, try everything out first on practice wood.

Re: Watco vs Deft Danish Oil

#4

Re: Watco vs Deft Danish Oil

Harry Ludke

I used to use Watco Danish Oil all the time. But, when I started building some Hal Taylor rocking chairs, he recommended Deft Danish Oil. I now much prefer the Deft Danish Oil. It seems to have quite a bit more varnish in it's mixture and leaves a very nice satin finish.The trick is to apply the first coat and really soak it, leaving no apparent dry spots. After 15 minutes I wipe it dry with paper towels repeating as needed until the oil stops bleeding out of the wood. Let it dry overnight and apply a second coat in the same manner. It will take much less Danish Oil and bleed less. Again let it dry overnight, rub out the nubs with a 1500 grit Micro Mesh sanding pad. Apply Carnuba or Butchers wax. Stand back and admire your work! :)

Fool proof system leaving a SMOOTH satiny finish that seems to hold up very well to daily use.

Re: Watco vs Deft Danish Oil

#5

Re: Watco vs Deft Danish Oil

Tom

I use watco, makes a very nice oil finish. When I need a more varnishy finish I mix some Maloof finish.

Re: Watco vs Deft Danish Oil

#6

Re: Watco vs Deft Danish Oil

Dave Bair

In a recent FWW article on finishing, the author indicated that Deft has stopped making their Danish oil. You might want verify and then stock up if true.

Re: Watco vs Deft Danish Oil

#7

Re: Watco vs Deft Danish Oil

Stuart Johnson

There's a couple long Deft threads over on the turning board.

http://www.woodcentral.com/woodworking/forum/turning.pl/md/read/id/475751/sbj/deft/

http://www.woodcentral.com/woodworking/forum/turning.pl/md/read/id/475926/sbj/good-news-for-deft/