Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Anyone ever tried wiping on WB Varathane Poly?

Posts

Anyone ever tried wiping on WB Varathane Poly?

#1

Anyone ever tried wiping on WB Varathane Poly?

Tim Greif - West of Chicago

I'm refinishing an old Mayline oak drafting table. I've done a couple in the past and have always used Watco on the oak frame and oil base poly on the top for durability. On this one, I used Watco to warm the wood color of the frame pieces, waited two weeks and brushed on multiple coats of Varathane Diamond WB poly to eliminate having to renew the Watco periodically. The table top is 72 x 38 solid maple and I was considering using the Varathane WB for that as well, but due to the large surface area, I would prefer to wipe on the finish to avoid any brush lap marks. I've done this in the past with Varathane oil base poly thinned 50/50 with naphtha. I would prefer to use the WB due to vapors in a closed up garage shop in winter. I've never tried wiping on water base finishes. I don't recall anyone ever mentioning it as a successful technique. Is this do-able?

Re: Anyone ever tried wiping on WB Varathane Poly?

#2

Re: Anyone ever tried wiping on WB Varathane Poly?

Howard Acheson

The problem is that waterborne finish dries very quickly. After all, it's and is going to evaporate fast no matter what you do. The only wipe-on waterborne I know of is a Minwax product.

Do not be tempted to just thin with water. Water is not a thinner for waterborne finish.

As always, test the finish on some scrap before committing to the real project.

Re: Anyone ever tried wiping on WB Varathane Poly?

#3

Jason Roehl in Lafayette, IN

Re: Anyone ever tried wiping on WB Varathane Poly?

Jason Roehl in Lafayette, IN

I can't imagine wiping it on would be feasible. It's just not made for that. If you need to cover a large surface area, you want a paint pad. Get it damp before you start (not dripping wet, but you want the sponge to have some water in it).

WB polys are generally best when they're put on about as thick as they can be without running. They're chemically quite complex, so avoid modification if at all possible (I've not yet found a WB poly I couldn't spray out of the can.) Thick-as-possible coats help keep them from drying too fast so that self-leveling can take place. Extreme temperatures and extreme humidity levels need to be avoided.

Jason