Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

wood bleach

Posts

wood bleach

#1

wood bleach

knugent

I read with interest your article on bleaching wood. I am in the process of restoring an old Winnebago motor home. I am rebuilding all the overhead cabinets with oak plywood, which I want to stain with a golden oak stain. I want to reuse all the old doors, but they were previously stained with a darker stain. The article says the chlorine bleaches will remove dye-based stains but not pigment-based stains. I have no idea which of these I am dealing with. Can you give me any ideas?

Re: wood bleach

#2

Ellis Walentine

Not so simple

Ellis Walentine

Cabinets almost always have a finish over the stain, so bleach won't touch the stain itself. Your best bet would be to strip the old finish and then sand it back to bare wood.

Also, there's no telling whether the original finish was dye or pigment based, though pigment stains tend to show up darker in the softer growth rings, so that could be a tipoff. Many times, the exact stain formulation is a mix of dyes and pigments. Nothing but experimentation will tell for sure.

Ellis Walentine, Host

Re: wood bleach

#3

Re: wood bleach

Howard Acheson

Some stains are a combination of dyes and pigments. Pigment stains contain a resin binder (think varnish) that holds the pigment onto the wood. Using a chemical paint remover will soften the pigment stain allowing it to be removed. However a chemical paint remover will do little to remove a dye stain. Dye stains are best removed by using a chlorine bleach.

So, removing an unknown stain may become a two step process. First use a chemical paint remover to remove the clear coat and the resin binder for the pigment stain. Once you have used the paint remover, apply the chlorine bleach which will remove most of the dye stain. Then you can re-stain using whatever dye or pigment stain you want.

Re: wood bleach

#4

Re: wood bleach

knugent

Thank you for that response. I have already sanded the poly finish manually, and the splotches of stain are still present. I did try an inconspicuous spot on the back of one door with laquer thinner, and it seemed to give pretty good results. Do you think that is a good idea? If not, should I try the chemical remover now, even though the poly is gone, then followed by the bleach?

Re: wood bleach

#5

Re: wood bleach

Howard Acheson

What is it you are trying to do? Are you trying to remove an existing finish preparatory to applying another finish? If so, what finish is on the item now and what new finish do you plan to use?

Basically, sanding is a poor way to remove an existing finish particularly if you plan to re-stain as part of your refinishing process. Sanding does not remove all the finish that might be absorbed into the wood. Any residual finish will cause problems of uneven coloring when you apply your new stain. If you did not use a chemical paint remover containing methylene chloride initially, do so now even if it looks like you were able to sand all the prior finish off.

Let me know what it looks like after you have used the chemical paint remover.