Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

advice needed on phase converter

Posts

advice needed on phase converter

#1

advice needed on phase converter

McKay

I purchased a 24" wide belt sander and the current phase converter is only a 5hp and the sander is 15hp. Where would be the best place to go to get a 15hp phase converter? Thanks in advance.

Re: advice needed on phase converter

#2

Re: advice needed on phase converter

Curt Stivison

I purchased mine from americanrotary.com. It's been good for 4 years without any problems. My neighbor installed on a 40hp belt sander and it worked fine.

Curt

Re: advice needed on phase converter

#3

Re: advice needed on phase converter *LINK*

John in NM

A friend of mine bought an assembled kit unit without the motor, since he had access to a bunch of large 3 phase surplus motors.

I think the company in the link was the outfit that made the setup, but I'm not 100% sure. There are others that sell you kits but IIRC, this was fully assembled and you just hooked your motor up to it.


Kits

Re: advice needed on phase converter

#4

Re: advice needed on phase converter

Thomas S Stockton

I got mine from american rotary also, really happy and it was pretty straight forward to install. It only took two trips to the hardware store.

I would call them and tell them your requirements and they will set you up.

Mines been trouble free for 6 years or so.

Tom