Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Sleigh bed question

Posts

Sleigh bed question

#1

Sleigh bed question

John Foster

Hello

We are working on the plans for a convertible sleigh crib/bed from the site below. We have purchased a standard mattress for this. Dimensions are 27 5/8 by 51 3/4. Our problem is the plans have a headboard/footboard that will accommodate a double bed in the future and measure 54". How do people make the standard crib mattress fit snugly up against the slats of a crib with a headboard/footboard that measures 54". In Canada and the CSA recommends only 3cm play between mattress and sides. The plans have the side boards for the double bed using the same holes as the side rails for the crib. We have already made the headboard and footboard but think it is too long. Any suggestions. Thanks

http://woodworking.ecrater.com/p/7031271/convertible-sleigh-style-crib-woodworking

Re: Sleigh bed question

#2

Re: Sleigh bed question

William Duffield, on the Cohansey

With a cursory view of the photos, it appears that the crib mattress is captured within the sides (rails and stiles), while the standard mattress hangs over the side rails. My calculations show that the overhang would be about 2-1/4" total, or just over an inch on each side, the same as the thickness of the rails. I don't see a problem, but I cannot see the support mechanism for the crib mattress. I assume cleats screwed to the insides of the rails, and slats under the mattress spanning the distance between the cleats.

Re: Sleigh bed question

#3

Re: Sleigh bed question

John Foster

Thanks for the reply.

We actually went to a crib store to see how the commercial convertible cribs were made, and got some ideas. I think we can make it work. The plans as received would have made it way too wide as a crib, with too much gap around the mattress. We like the design we are building, and are almost done the crib. We however have found several errors in the plan which could have been disastrous if not caught in time. Also my wife and I who have moderate skills in woodworking and a fairly well equipped shop are taxed to our limit doing this project. Some beginner with just a few tools in their garage would be in way over their heads if they had bought these plans. Maybe they should have given a warning about the skill level required.

Thanks again

John