Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Crystal Varnish Repair on floor

Posts

Crystal Varnish Repair on floor

#1

Crystal Varnish Repair on floor

Bill from Montreal

I have a relatively new house with stained oak flooring with Crystal (urethane) varnish on top.

In many places, the varnish has glued the boards together in bunches, and about every 4-6th gap between the boards open the gap in the winter when the collective bunches shrink. (Called Block effect)

My problem is in a couple of places, the varnish has lifted off or cracked away from the stained flooring, leaving areas withbare stained oak. Luckily so far, the stained wood is still intact

Although the Crystal varnish surface has held up well, our two labradors refuse to wear the slippers provided, and some marking of the surface is present

Crystal (urethane) varnish is no longer available in Canada due to VOC and pollution restrictions.

resanding the entire floor should not be necessary (and undesirable - the stain is dark and would require a deep sanding)

- I think a recat should fix it if I can find something to bond to the Crystal

I want to

a) repair the chipped spots (three sections, about 24-30" long total)

b) consider recoating the main floor to reduce or hide the dog scratches

Any Suggestions? What sticks to urethane, for spot repair, and for general recoat after light sanding....

Re: Crystal Varnish Repair on floor

#2

experience

Bill Tindall, E.Tn.

I don't know the details of this particular varnish. In 1970 I put three coats of the old fashioned moisture cured urethane on oak floors. Dog nails don't dent it. Fifteen years, an English setter and two kids later I scuff sanded it (I think 100 grit) and recoated with the same. No problems were encountered.

The blocks of flooring with cracks in between are nothing to do with the varnish. That is just how every floor I have had experience with shrinks.

I suspect the stain was not cured where the varnish lifted.

Re: Crystal Varnish Repair on floor

#3

Re: experience

Barry Irby

I wonder what your subfloor is? If the cracks that appear in winter roughly correspond to cracks in the subfloor, it called "rafting" or "panelization". the concept is that the flooring is nailed to the subfloor and the urethane glues the strips together. Both shrink in winter but the urethane causes the flooring to sort of ride on the subfloor and move with it, keeping the cracks between the boards in the field small and fairly closed up. Where the pieces of subfloor shrink away form each other, the cracks "accumulate" and show up fairly wide cracks.

Plywood is more stable than OSB. The Floor industry fought against OSB, demanding plywood under oak flooring. Eventually, they capitulated.

I think Bill is right. If you scuff sand Or "screen" your existing new urethane should adhere fine.

Re: Crystal Varnish Repair on floor

#4

I would only accept advice from the manufacturer *LINK*

Dick Coers

You may get a lot of people telling you it's okay, but I would only trust advice from 2 places. 1 is from people that have used the EXACT finish schedule and finishes you used, and 2, the manufacturers. #2 will give you the best advice!

You mention some minor adhesion from the stained wood already, adding more of anything may really give you a mess. Test your work inside a closet if possible.


http://timberprocoatings.com/wood-finishes/crystal-urethane.html