Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Finish Question

Posts

Finish Question

#1

Finish Question

Tom

I have a vanity that was finished with Magna Lac nitrocellulose lacquer. I want to do some touch up with some tinted shellac to take care of some wear points. I want to top coat it with Old Masters oil based varnish.

Do I need to use a de-waxed shellac between the two finishes?

Thanks

Re: Finish Question

#2

Re: Finish Question

Dave Bair

Yes, dewaxed to insure bonding of the finishes to each other.

Re: Finish Question

#3

Re: Finish Question

Howard Acheson

>>>> Do I need to use a de-waxed shellac between the two finishes?

No, you do not need to use dewaxed shellac. The criteria for using dewaxed shellac is when you are dealing with oil based poly and/or any waterborne finish. None of the products you say you will be using are urethanes or waterborne so standard non-poly varnish will adhere nicely. But, I would scuff sand the NC lacquer thoroughly to insure a good bond.

Re: Finish Question

#4

Re: Finish Question

Tom

Thanks!

Now I remember I used a oil based poly over lacquer and I was advised to use dewaxed shellac. It was on a set of oak stair treads and it has held up great.

Re: Finish Question

#5

Re: Finish Question

Howard Acheson

>>>> I was advised to use dewaxed shellac.

There was/is no reason for that. Again, the only time there is an issue with shellac is if you plan to use a poly varnish on top of the shellac. Standard, non-poly varnish can be applied over a non-dewaxed shellac.