Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Lathe maintenance

Posts

Lathe maintenance

#1

Lathe maintenance

Robert Burgess

I have a Craftsman Professional Variable Speed Wood Lathe, model #351.217150. It is in good working condition however, it was not used in quite a bit (due to accident).

I turned a pen the other day and found that it was out of round. I believe that as I cut, sanded etc the spindle pushed to the rear. I'm not sure if possible bearings are out, or????

I have looked into buying a new one and found for the money and the power, variable speed and all accessories I have, it would be better to get this one fixed. Only problem is ..... where?

I am not sure who or where works on them. I am located in Queen Creek and would appreciate any info on where I could take it to get it fixed. I can do a lot of handyman type things, but think this is a project I could really ruin. Any advice would be greatly appreciated.

Thanks (as you can probably tell, I am an amature turner who loves to play, I have the shop, etc., just need advice).

Re: Lathe maintenance

#2

I can't diagnose -

Henry W

Robert - Welcome to WoodCentral.

There is a Turning specific board here - people hanging out there may be more able to answer you. Look for the MESSAGEBOARDS link at top left of the page - and select TURNING. I'd suggest posting there as well for more answers.

That said, I am not certain that your diagnosis is correct. I believe that too much sideways pressure while spindle turning can result in the effects you describe, even if your lathe is perfectly aligned.

Henry

Re: Lathe maintenance

#3

Re: Lathe maintenance

Dave Bair

Post this on the WoodCentral Turning Messageboard for quicker replies. I have no answer for you.

Re: Lathe maintenance

#4

Re: Lathe maintenance

Dick Coers

An out of round pen is caused by too much pressure from the tailstock. It bends the mandrel. You can straighten the mandrel, then just snug up the live center. Most pen turners have now gone to turning with special bushings and centers to drive them. No mandrels used. Others use a mandrel saver live center that puts the pressure on the blank and not the mandrel. If your bearings were bad, you would easily be able to tell from noise.