Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Edge cutting a thin sheet

Posts

Edge cutting a thin sheet

#1

Edge cutting a thin sheet

Ralph Lipeles

I am making drawers for my just completed miter saw stand and needed to cut the 1/4" sheets for the drawer bottoms. I had 2 pieces of 1/4" plywood. I also had 2 sheets that were faced and were about 1/64" thicker. My choices were to recut the the grooves in the drawer pieces or reduce the thickness down to 1/4" I wanted to reduce the thickness but did not have a zero clearance insert. I looked around the shop for ideas and spotted a pair of 1/8" thick blade stabilizers. I put them both on the saw arbor and that shifted the blade by 1/4", just 1/16" from the edge of the slot in the table insert. That setup worked perfectly.

Re: Edge cutting a thin sheet

#2

Ellis Walentine

Got it done

Ellis Walentine

... or is that "got 'r' done?" Woodworking is all about improvising. It sounds like you improvised this one successfully. Good work, Ralph.

Ellis