Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Need gluing help, ideas

Posts

Need gluing help, ideas

#1

Need gluing help, ideas

Gary clarke

I want to glue up a series of boards with varying thickness (1/4 to 3/4) x21 long x 10 wide. Each board needs to be 1 1/2 in ht. the problem that I have had is getting the boards even in ht. I have tried using cauls clamped over each end and I get close to even but no cigar. Any suggestions will be appreciated.

Re: Need gluing help, ideas

#2

Clint Searl

Re: Need gluing help, ideas

Clint Searl

Upside down on a flat surface.

Re: Need gluing help, ideas

#3

Re: Need gluing help, ideas

Yonak

Gary, would it work to do the best you can gluing, making them a bit too thick, then plane off the excess ?

Re: Need gluing help, ideas

#4

Re: Need gluing help, ideas

Dick Coers

Don't try to glue them all at once. Can you pin all but the outside ones to hold them flush?

Re: Need gluing help, ideas

#5

Re: Need gluing help, ideas

AZ in Colorado Springs

I agree with Clint's suggestion. I accomplish such glue-ups with the jointed (flattened) faces down, on the bar clamps. Then, I just make sure those flattened faces line up on the bottom of the glue-up. After the glue has cured, plane the top (uneven) face and you're good to go.

Re: Need gluing help, ideas

#6

Re: Need gluing help, ideas

gary clarke

thank you all for your suggestions