Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Outdoor sign repair

Posts

Outdoor sign repair

#1

JL

Outdoor sign repair

JL

I've been asked to repair an outdoor sign.

It consists of a plywood backing w/ a 2 x 4 frame around it. There are two pieces of plywood cut in a relief outline of mountains on the plywood backing.

The backing is pretty much toast - it has delaminated in places on the back and is starting to rot. I would like to "peel" the outline of the mountains away from the backing and glue it to a new piece of treated (or marine) plywood.

So - I really need to peel the mountain outline from the backing plywood, repair that as necessary (epoxy putty??) and make a new backing and frame.

Any suggestions as to what I can fill the the mountain outline with? Any suggestions on how to peel the layers apart?

I don't know the glue.

Re: Outdoor sign repair

#2

Re: Outdoor sign repair

don stephan

Before you start, a tracing of the mountain cutouts might be advisable. You might be able to sand the remnants of the backer plywood from the cutouts. I'd just make all new.

Re: Outdoor sign repair

#3

Jack Guzman from Maine

Re: Outdoor sign repair

Jack Guzman from Maine

I would probably cut out the profile of the mountain backdrop with a jigsaw and use it as a pattern to make a new one. Either that or try to get a tracing off the old one. If that piece is actually glued on,any product you use to loosen the glue will probably delaminate the plywood of the profile piece also. If that back piece is ruined the profile piece is probably pretty close behind. Is there any reason not to make a new one?---Jack

Re: Outdoor sign repair

#4

JL

Re: Outdoor sign repair

JL

Well - the person who did the original cut-out cut out some nice trees.

One of the trees is applied to the cut out mountains. I'll try to peel them apart and see what happens.

It could be that I just trace them and do a totally new sign.

Re: Outdoor sign repair

#5

Know the glue, know the answer

Grant in Iowa

I would attempt to understand what type of adhesive was used. If it is an epoxy, you can usually heat it to 150 or so degrees with a heat gun and convince it to let go. If it was gorilla glue, you will need to resaw it apart in some way, as there is no known glue remover for that stuff. see if you can figure out the glue then repost. A picture is also worth a thousand words, as I am not sure I quite understand the layout.

Suggest MDO or the new Extira or Medex for the replacement backer. I think Medex uses phenolic resin as the binder and be immersed in water for weeks with no deformation by my experimenting.

Determine if the backer is glued on or nailed/ screwed on from the back and you will know how to proceed.

Give us a bit more info and we'll try to offer better help.

Regards,

Grant in Iowa

Re: Outdoor sign repair

#6

Re: Outdoor sign repair

Merle

Depending on the size of the sign, you could remove the backing by running it through a drum sander? Also, MDO (or even HDO) is used for road signs and would hold up well for this application.

Re: Outdoor sign repair

#7

JL

Hadn't considered MDO

JL

Will it work?

Re: Outdoor sign repair

#8

Re: Hadn't considered MDO

David Yoho

JL, I wondered why you didn't mention it as a choice in your original post. MDO, if you can get it in your area, is what's traditionally been used for outdoor signs. Yes, it will work.