A Fun Little Project
Rod Peterson—Ormond Beach, FL
I've been dissatisfied with the tool post clamp on the banjo of my Delta 46-701 lathe for some time. It's basically a 5/8" headless bolt with a tommy bar for leverage. The nature of the bar gets it in the way more than it helps.
The other day, I noticed Tommy MacDonald tightening the clamp on his Powermatic mortiser in an episode of PBS' Rough Cut, and noticed a flat blade in the shaft of the clamp which is an ever so much more elegant application. I thought I'd investigate crafting one.

Above is a view of the old and the new—OEM clamp on the left and my new one on the right. But to get to this result required some work. First I found a bolt. It turns out to be a standard SAE thread bolt. I took it home, hacksawed the head off and hacksawed half of the foot off, and then contemplated the slot.
I am not a machinist (although I have a survey understanding of a lot of the processes), but it didn't take a lot of thinking to realize that machining a slot in the end of the bolt was going to require more than a hacksaw and a file. So, I found a local machine shop who milled a slot for me.
On the way home I had stopped at the local hardware store and picked up a 1/8" roll pin to serve as a pivot. Then I hacksawed some flat stock to make whatever that wing thing might be called. Some time at the grinder and a couple of holes later I had the final result below:

Here is the new clamp attached to the banjo. Preliminary fumbling seems to be promising. It'll be a few days before I roll the lathe out of the shop for a test spin. Already I like it, though. Oh, a newly acquired 4" tool rest showed up today, too, so I get to try out all kinds of stuff.

Hey, not all projects are masterpieces…
Rod



