Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Imperial Star Destroyer Work Bench Light

Posts

Imperial Star Destroyer Work Bench Light

#1

Imperial Star Destroyer Work Bench Light

GolfSteve in Calgary

I ran across a natural edge curly maple board that I though would make a nice light above my work bench. The old 2-bulb fluorescent above the bench was deficient.

I installed LED strip lights (14 Watts/meter, 60 LED/meter, natural white 4000K, no idea how many lumens). Very bright. 5 meters of LED strips is brighter than four 40 W fluorescents. The LED strips are inside 1/4" x 3/4" recessed aluminum channels.


One edge of the board was natural-edge. The other edge was slashed up with a chainsaw, so I "natural-edgified" it with some carving gouges.


The final product reminds me of an Imperial Star Destroyer. I moved the 2-bulb fluorescent that was above the bench to the rear of the workshop, doubling the light back there.


The extra light and improved colour is a nice improvement for my bench. The new light is also parallel to the bench whereas the old fluorescent was perpendicular, which I think is a small improvement.


Re: Imperial Star Destroyer Work Bench Light

#2

Re: Imperial Star Destroyer Work Bench Light

Alan in Little Washington (NC)

Do the aluminum channels provide enough of a heat sink? How did the cost compare with a florescent fixture?

Re: Imperial Star Destroyer Work Bench Light

#3

Re: Imperial Star Destroyer Work Bench Light

GolfSteve in Calgary

The LEDs don't get very warm - the strips run about 50 deg C by my calibrated hand. The transformer gets very warm - around 70 deg C.

The cost was $150 CDN (approx. $145 USD) for 5 meters of LEDs, $85 for the channels, and $45 for the transformer, total $300, so it was more expensive than fluorescents.

I bought these at a LED lighting store on a whim. I know Lee Valley carries a similar product but don't know how their product compares. The part number of what I bought is Flexstrip-05-5630-60LED/M-4000K.

I originally wanted to use 5 or 6 PAR20 halogens, but the pots/enclosures were either cheap large and ugly (they would be visible above the board), or they were expensive. It was also going to be a pain to drill or route 3.75" diameter holes in the board.