Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Finishing suggestions

Posts

Finishing suggestions

#1

Finishing suggestions

Keith Newton

I have a client wanting me to put a shiny finish on a carved piece made from Catalpa, which I have already bleached. I like the flat look myself, but she insist that it have a higher finish.

I'm afraid that if I put a wipe on penetrating finish, that the bleached out surface will just turn muddy.

I was wondering about using a liming wax, but I don't have any on hand, and not sure I can find it locally, and don't know if it offers a sheen, or not?

Would using a couple of light misting spray coats of acrylic be the best sealing coat for the bleached area?

Re: Finishing suggestions

#2

Maybe Not

Mark Mandell - Gone Round In New Jersey

The acrylic, being a waterborne, will raise the grain and interfere with the clarity of the finish film.

Without seeing the piece [caveat] . . .

I would probably do it thus:

1. Mist with water to raise the grain.

2. When dry, mist on a thin (1/2-3/4 lb cut) of ultra pale dewaxed shellac. This will dry quickly and stiffen the raised fibers; option is artist's "fixitive" like Krylon.

3. "Scrub" the surface with a piece of gray synthetic wool pad moving in line with the grain.

4. Vac the surface very well with a brush; option to also use high pressure air.

5. Apply 1st mist of acrylic. Allow to dry well.

6. Rub gently with your gray pad to catch any stray fibers. Vac off well.

7. Apply your final acrylic coats to build to desired gloss.

Re: Finishing suggestions

#3

Ellis Walentine

Lacquer it

Ellis Walentine

Quick, easy, pick the sheen and build the customer likes.

Ellis

Re: Finishing suggestions

#4

Re: Finishing suggestions

Dick Coers

Gloss on catalpa is going to have a different look. The early grain is so porous, the film is going to build on the hard grain, but then you will have open pores. There are some water white lacquers out there too. Depending on the details of the carving, I would be reluctant to whisker it as mentioned. You may loose some crisp edges with the Scotchbrite. I've actually filled catalpa pores with acrylic paint, then sanded it back. One hollow vessel filled with red paint, sold very quickly at a show.

Re: Finishing suggestions

#5

Clint Searl

Yeah!


Re: Finishing suggestions

#6

Re: Finishing suggestions

Patrick Gibbons

Use pumice and rotten stone to take off raised grain and to fill pores. It becomes invisible under finish. I like bleached shellac.