Some thoughts: *LINK*
Grant in Iowa
You can check a fluorescent tube by checking continuity between the pins on each end. Generally, you will find that a burned out tube will have no continuity at one or both ends. Tube failure is rarely due to any other issue. The blackening you see is often due to the filament in that end overheating and burning out. When this happens prematurely, you often didn't have the bulb in quite right, or you might have a loose wire somewhere. Less often it can be the result of a bad ballast.
You will NOT get continuity between opposite ends of a tube....this is normal.
Many issues with fluorescent fixtures can be traced to poor connections where the tube contacts the lamp holder. Inspect closely and ensure your tubes are nicely seated by rotating them back and forth a time or two.
Philips T5 tubes do not presently require a burn-in period as some other high efficiency tubes do. Make sure you check packaging and instructions for this information and comply for maximum life span.
Here is more info regarding rapid start, instant start, etc. that would be a good read to ensure you have the right variety for your purpose.
FWIW,
Grant in Iowa<---mild manner facilities guy by day
Luxadd T-5 info