Re: How does one measure in Hoppus feet?
Sgian Dubh
You'll need to read the book for simple explanations for a host of things Bill, including this subject ... but if it gets published you are one of the few people I've promised a free copy to anyway in acknowledgement for the help you've provided in the past, but here goes anyway. I think the explanation below is definitely easier to follow than the one in Patrick's link! (That was a tongue in cheek joke, by the way.)
Hoppus Feet (h ft) is the system devised by the English surveyor Edward Hoppus and appeared in a 1736 manual. It’s been in use by British foresters since then. It is said now to be redundant because the British timber industry converted to metric measure in 1971. This might be true but I still buy wood by the cubic foot, and timber merchants are as adept as I am at converting between metric and imperial units. As we buyers and sellers of wood are in the habit of converting between units of measure it’s useful to know that conversions exist between Hoppus feet and cubic metres, viz., one Hoppus foot equals 1.273 true ft³ and 27.74 h ft = 1 m³. 1 h ft = 0.03605m³. A Hoppus foot is roughly 21 percent less than a true cubic foot. There is an allowance built in to the h ft for the loss of material during the milling of a butt or log. For comparison a cubic metre is the same as 35.31 true cubic feet, which is almost the same as 424 board feet, with board feet (bd ft) being the standard measure of wood or lumber in the US where a bd ft, is 1/12 of a cubic foot.
Hoppus Feet
A calibrated girth tape takes log measurements. The user wraps the tape around the log and reads off the Quarter Girth (QG) in inches from the scale. The Hoppus Feet yield of hardwood round logs (sawlogs) and veneer logs is calculated by taking 1/4 of the logs girth in inches at its midpoint in the length, squaring the result and dividing this by 144. Finally the number of log length feet multiplies the result of the previous sum. The formula is written: Hoppus Volume (h ft) = ((Mid Quarter Girth in inches)²/144) X Length in Feet.
To put some numbers to this formula, let’s say the girth of a 16 foot long log measured at the midpoint of the length is 69 inches. Wrapping the calibrated girth tape around the log provides a reading of 17.25 inches. This, incidentally, is equivalent to a circle of 22 inches diameter, although here of course we’re not dealing with a perfect circle, we’re dealing with a rough log.
Example Sum 1: (17.25² / 144) X 16 ft = 33.06 h ft. For those more familiar with board feet (bd ft) i.e., primarily North Americans, multiply the result by 12, thus 33.06 X 12 = 397 bd ft.
Example Sum 2: A log 16 feet long with a 38 inch mid-length girth, i.e., a quarter girth of 9.5 inches as read by the calibrated tape. Calculate: (9.5² / 144) X 16 ft = 10 h ft or 120 bd ft. This log would have a theoretical mid length diameter of approximately 12” if it were a true circle.
There. Clear as a bell I assume, and I really don't think this sort of information about timber technology is at all esoteric, a charge I find both amusing and intriguing in Clint Searl's response in my thread on the manuscript I've finished, where he reckoned 99% of the subject matter listed in my Table of Contents was "too esoteric". That response would lead most readers to conclude that Clint has almost no interest in woodworking at all, but I really don't think that's the case, ha, ha. Slainte.