Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

OT Anyone tried patching/Repairing Vinyl flooring

Posts

OT Anyone tried patching/Repairing Vinyl flooring

#1

OT Anyone tried patching/Repairing Vinyl flooring

Barry Irby

In my rental house I have found several small holes in the vinyl flooring. Holes about a half inch in diameter. And some scratches or cuts. I have been looking on YouTube and have found several videos. Went to the borg today to get some seam sealer. No Go. Might be able to get some from a dealer of some sort.

I was thinking of alternative methods. Could I take a chisel like a hollow chisel from a mortising machine and punch out a half inch square and then use it to punch a matching plug out of a spare piece of vinyl, which I have? Then glue the plug in the hole with either seam sealer or CA or epoxy?

Could I fill the holes and scratches with epoxy or CA?

The holes are not bad and I want to get another cycle out of the vinyl. Just looking for something better than nothing. Anybody got a creative solution?

Re: OT Anyone tried patching/Repairing Vinyl flooring

#2

Re: 1 cycle

Mark Mandell - Gone Round In New Jersey

A shot of clear silicone in the hole/cut, cover with waxed paper and a brick.

Done

[ps: remove the brick and paper when set ;) ]

Re: OT Anyone tried patching/Repairing Vinyl flooring

#3

Re: OT Anyone tried patching/Repairing Vinyl floor

Bill Howatt

You should be able to get seam sealer, I know I got some years ago but that my have been with a seaming kit.

I think a problem without sealer may be that the "joints" will capture dirt and if the vinyl is a light color you will see a ring around the patch.

Bill

Re: OT Anyone tried patching/Repairing Vinyl flooring

#4

The vinyl is about the color of Travertine.

Barry Irby

It is made to look like grouted hard tiles.

I like the idea of the silicon. Actually my "make it as complicated as possible gene" is twitching. But this may be a good time to take the easy way out.

Re: OT Anyone tried patching/Repairing Vinyl flooring

#5

Re: The vinyl is about the color of Travertine.

Tony-Memphis

The best technique I have seen is to cut out a whole "tile" following the "grout" lines and replace it. Thats what the maint. folks dia t my old apartment. Actually looked pretty good. I have a couple of spots on our flor I need to repair - same situation. I caused them by sliding appliances across the floor - the feet got stuck and caught on the vinyl - oops!

Tony

Re: OT Anyone tried patching/Repairing Vinyl flooring

#6

Kneale Brownson

Re: The vinyl is about the color of Travertine.

Kneale Brownson

If you can locate the patch material over the damaged material so the "grout" lines are on top of eachother and then cut through BOTH pieces of tile at the same time, you'll have a matching seam that will be easier to hide.

Re: OT Anyone tried patching/Repairing Vinyl flooring

#7

Saw that on YouTube....

Barry Irby

and in person, but my experience was that it turned a half inch square problem into a 12" square problem. In this case the worse offender is a hole that landed almost exactly in the "corner" grout of four tiles, that is, right in the intersection. I would have to "replace" four tiles or a piece about two feet square right in the highest traffic area. At the level this rental is at I might be better off just leaving the hole or filling it with clear silicon. That"s part of the reason I was interested in punching out a small patch.