Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

35 pound table leaf wt reduction plan

Posts

35 pound table leaf wt reduction plan

#1

Chris Groves

35 pound table leaf wt reduction plan

Chris Groves

I am nearing the completion of an arts & crafts 60" round table with two 20" leaves. The table is made from curly maple and the top is 1.25" thick... The problem is the leafs with aprons weigh a robust 35 pounds. my plan is to remove some stock between the aprons by routing 2' wide strips (leaving 3/4" thickness) so the leafs can sit on the maple table slides (paxton 5 section) and still have plenty of thickness. I am hoping to remove about 8-10lbs to make the leafs more easily moved and stored under beds.

The aprons are keeping the leafs from warping... should I add a ctr stiffener similar to the 7/8 by 2.5" aprons?

thanks for any input- Chris

Re: 35 pound table leaf wt reduction plan

#2

Chris Groves

Re: 35 pound table leaf wt reduction plan

Chris Groves

2 inch wide strips...

Re: 35 pound table leaf wt reduction plan

#3

Re: 35 pound table leaf wt reduction plan

don stephan

Hoping you didn't mean that the leaves are warped and pulled flat by the aprons . . . and the aprons have to allow seasonal movement in the leaves.

Not sure anyone can guarantee milling the slots you describe won't upset the existing internal balance of stresses in the leaves and make them want to cup or twist.

Are the leaves made from flat, rift, or quarter sawn lumber?

Re: 35 pound table leaf wt reduction plan

#4

Chris Groves

Re: 35 pound table leaf wt reduction plan

Chris Groves

The leaves are not warped... the panels are made from 3 pieces of flatcut maple

Re: 35 pound table leaf wt reduction plan

#5

Re: 35 pound table leaf wt reduction plan

Grant in Iowa

I would consider ripping them down to make four 10" leaves of 17.5 lbs each.

I guess the question regarding your approach really is: What is the cost of failure? If you rout out the bottom to make them lighter, and they subsequently warp or crack, can you reproduce replacements with the figured wood?

Another approach would be to glue both of the 20" leaves together and then rip them in to 3 equal parts of 13.3 inches. If you could do this seamlessly, this would be my preferred solution. A benefit is that a 13" board that warps would be much less noticeable than a 20" board that warps.

There's a reason that most leaves aren't that wide. You may have unwittingly found it.

Woodworking is not a craft of perfection, but rather a craft of learning how best to hide mistakes.

FWIW,

Grant in Iowa

Re: 35 pound table leaf wt reduction plan

#6

Chris Groves

Re: 35 pound table leaf wt reduction plan

Chris Groves

Thanks for the input... I think my solution will be to go ahead with the routing in an anti-warp pattern (TBD) and to add a center apron to help prevent bowing... i will finish the bottom thoughly and hope for the best... the table is for my sister so she knows where to find me if trouble lies ahead... i am willing to remake them if necessary into thirds as Grant suggested..

Chris

Re: 35 pound table leaf wt reduction plan

#7

Chris Groves

Re: 35 pound table leaf wt reduction plan

Chris Groves

here is a picture of one of the leafs after routing out 4 sections... the table top is 1.25" thick and I routed to a depth of 5/8.... total weight reduction of 7 lbs


img