Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

SAC F430 Jointer Users?

Posts

SAC F430 Jointer Users?

#1

SAC F430 Jointer Users?

Steve Elliott

The shop I work at is considering buying a used SAC F430 16-inch jointer. Does anyone here have experience with this model? I'm especially interested in how accurately the insert knives can be aligned with the outfeed table.

I believe the jointer would have a Tersa head, something I'm not familiar with.

Any information about this model would be helpful, especially possible problems with its design.

Re: SAC F430 Jointer Users?

#2

Re: SAC F430 Jointer Users?

Thomas S Stockton

Steve

Don't have a SAC but have a Griggio with a tersa head and they are very accurate.

Takes 2 minutes to change the knives and you can keep an old set around for less than clean wood since the change over is so fast to prevent trashing a good set.

Mine came with a dummy pair of knives so that if you run carbide you only have to buy two instead of 4. I've never used them and get good life out of m42 knives.

Tom

Re: SAC F430 Jointer Users?

#3

Re: SAC F430 Jointer Users?

Robin Corell in Atascadero,CA

I don't have any experience with that joiner either but I have spent some time using a friends mini max with a tersa head. Tom was not exaggerating about knive changes taking only 2 minutes. There is no need to touch the adjustment on the outfeed table during a knife change and the way the head and knives are designed they are always on the exact same orientation.

Robin

Re: SAC F430 Jointer Users?

#4

Thanks to you both for helpful info