OT: Outdoor cut Christmas tree Q's
Grant in Iowa
I have been tasked at work with getting a cut Christmas tree and building a stand to erect it outdoors where it will be decorated with lights. The request is to obtain it shortly after Thanksgiving and to keep it on display until after Christmas. Figure 30 days. I think the species we will be donated is blue spruce.
Since it will be a live tree (well, up until it is cut), how does one go about watering it when it is below freezing outside? Heat tape in the water or around the water reservoir? Is it even necessary to water it given it is winter and it will be near or below freezing most of the time? I know indoor trees must be watered, but how about outdoors in sub freezing temps?
The goal is to use about a 12' tree, which may have a butt end of up to 10-12". My preliminary plan is to weld up a steel stand that can support it without guy wires. This stand would have a capped piece of steel pipe about 16" tall as its center to hold water, and four pieces of steel tubing radiating out from the pipe to create outriggers. These can then be staked as necessary to resist wind. I would drill and tap 4 holes around the top of the pipe to receive "set screws" to allow for plumbing the tree and to hold it in place. A short spike would be welded inside on the bottom to hold the butt end.
Anyone installed a live cut Christmas tree in below freezing temps? Any advice would be appreciated. I don't want to be "the guy with the dead Christmas tree".
Thanks in advance,
Grant in Iowa



