Doors warping - spruce lumber for sets?
JL
I build sets for the local theatre group. Little or no budget - therefore I have to use spruce or equivalent lumber from the building supply company.
The 2 x 4s and such are stored outside under metal roofs but are otherwise exposed to the elements. I always take care to get straight lumber without a lot of blemishes or knots.
I've built some "French" doors out of ripped 2 x 4s (ripped to 3" or so). By the time they've sat for a couple of days, they have a tendency to warp a bit. Not quite to the potato chip stage
, but not pretty. Typically one side is out by 1 1/2" or so.
Thoughts for solutions? I've time invested in them, but I'd rather they look right - and have the ability to store them for future uses.
Should I go to Home Depot or Lowes and use their 2 x 4 stud lumber? It has the advantage of being in an air conditioned building and is probably drier (or not).
Should I search for near quarter sawn lumber at H.D. or the building supply place?
Any other solutions?
Again - we have a small budget.



