Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Sears Craftsman "100" table saw

Posts

Sears Craftsman "100" table saw

#1

Sears Craftsman "100" table saw

John Rolph

I also have a Craftsman 100 table saw and use it a lot. It has the cast extensions on the left side and a support system in the right side. I would like to upgrade the fence system to an Incra Jig TS-LS table saw fence or a TS-LS Joinery system. My question is will the Incra systems fit the saw or am I wasting my time thinking about an upgrade?

Re: Sears Craftsman "100" table saw

#2

Re: Sears Craftsman "100" table saw

Henry Higginbotham

Call Incra -- they'd know. I suspect it would work, even though I have no idea what your saw looks like. Incra's fences are adaptable to almost anything.

I've had one on my Unisaw for at least 14 years. I have to remove it to use a crosscut sled, so it has been on and off quite a bit. I've never had to adjust it after the initial setup. Set it back onto the rails, slide against the stops, tighten the locks, and everything's fine 14+ years later.

Re: Sears Craftsman "100" table saw

#3

Re: Sears Craftsman "100" table saw

Jerry Nicholson

I had no trouble installing a Delta Precision Saw Guide (think Unifence lite) on my Craftsman Model 100 15 or 20 years ago and I assume that other kinds of guides can be made to fit too. Tremendous improvement over the original Craftsman guide! I am sure I had to drill some holes in the front edge of the saw table to install the track for the Delta saw guide.

I replaced the open grid (finger pinching!) cast iron extensions with inch and a half thick MDF Formica covered extensions long ago. I have considered replacing this nearly 50 year old Craftsman several times but it still seems to do the job just fine and I have had it for so long it seems like one of the family now.

Jerry