Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

turning on a wood lathe

Posts

turning on a wood lathe

#1

turning on a wood lathe

Jack Putnam

When you are turning on a wood lathe and the object you are shaping what is the best way to cut the excess ends off so that both finished ends are flat that when it stands up there is no wobble to it. I have tried a band saw and it does not cut that straight it still has to be sanded to to make it flat. I even tried using a sander but I have to be careful not to sand it at an angle. Thanks for any help.

Re: turning on a wood lathe

#2

Jack Guzman from Maine

Part it off

Jack Guzman from Maine

Use a parting tool and cut the end that will be standing off at the lathe while turning slowly.I will sometimes slightly undercut this end and use a sharp chisel to remove the little nub that is left.

You will get more responses at the turning forum.Lots of knowledgeable lathe people there.---Jack

Re: turning on a wood lathe

#4

JL

Re: turning on a wood lathe

JL

I do things a bit differently.

I undercut the piece with a parting tool as the others do until I'm close to the center nub. I then use a skew chisel and get a smoother finish after hogging out most of the waste with the parting tool.

If the only thing touching the table (or whatever) is a thin rim - it won't wobble.

Re: turning on a wood lathe

#5

Ditto what JL does-check out link  *LINK*


http://www.youtube.com/watch?v=tZVlhr9fLCM