Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

question-refinish kitchen cabients

Posts

question-refinish kitchen cabients

#1

question-refinish kitchen cabients

Bill Tindall, E.Tn.


After 21 years it is past time to refinish as seen by the area under the knob where the sun don't shine. The finish was a non-aromatic urethane conversion varnish from Sherwin Williams. It was advertised to not yellow. It did and the ash turned brown to boot. A methylene chloride stripper softens this finish nicely and it comes off with coarse steel wool. But it leaves behind what I consider the unattractive yellow brown ash. Sanding the flat parts to remove the stripper film and to brighten up the wood will be easy. But....


Does anyone have any hints for how to deal with the recess where the panel meets the frame? (other than brute force tedious hand sanding with scraps of sandpaper?)

Re: question-refinish kitchen cabients

#2

Re: question-refinish kitchen cabients

don stephan

No clue what the results might be but there are I think three types of wood bleach.

Re: question-refinish kitchen cabients

#3

Re: question-refinish kitchen cabients

Dave Arbuckle, Plano, TX

Don is thinking the same direction I was.

I would see if oxalic acid would brighten the wood back up. Might, might not, but if it did seems easier than sanding.

Re: question-refinish kitchen cabients

#4

Ellis Walentine

Pros and cons

Ellis Walentine

You could make the ash really white with two part bleach, but it's not the kind of job you can do in situ. If it's just the doors and drawer fronts that need bleaching, this would be a good way to get a nearly white appearance.

If you're happy enough with the aged ash look and just want to brighten up the recesses, sanding may be the only decent option. I would imagine you could make up a custom-contoured sanding block from styrofoam insulation and wrap some 320 grit around it to make this job go a lot easier.

Ellis

Re: question-refinish kitchen cabients

#5

progress report

Bill Tindall, E.Tn.

To my surprise the ash itself is colored deeply from age and sun. 80 grit on an air driven ROS doesn't get me to original wood color, so I gave up trying. I have sanded to get the wood about half way back to original wood color. It is a lot of work. In a day I have only finished two base unit sections, 11 drawer fronts and 5 doors. Sanding the base unit framing...by hand, is slow. I still have 4 base units and 12 doors and 4 drawer fronts to go. On the bright side the original finish strips easily or in the case of flat surfaces I just sand it off.

Re: question-refinish kitchen cabients

#6

Re: question-refinish kitchen cabients

Larry Clinton At Frankfort, (Central) Indiana

Bill - I am not sure about the finish, but I have had pretty good luck using custom shaped scrapers for removal of old finishes in the areas you are describing. I do usually final sand though as the scraper does leave a smoother surface that won't take the finish/stain the same as sanded wood. Most of the time I don't even have to make a new scraper - bought several in assorted shapes from Lee Valley a few years ago - they do work well.

Re: question-refinish kitchen cabients

#7

Re: progress report

paul in AZ

This was discussed recently but here goes. Ash will not stay white. I have a couple of pieces I built using no stains maybe 30 (?) years ago that are now a very pleasing -to me anyway- honey color. Just the nature of the beast.

Re: question-refinish kitchen cabients

#8

Re: question-refinish kitchen cabients

Bill White

Larry beat me to the cabinet scraper comment.

Bill