Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Craftsman RAS reassembly

Posts

Craftsman RAS reassembly

#1

Craftsman RAS reassembly

Jpleech

Long story here, but I'm trying to reassemble my 1970s craftsmn ras. The shaft that raises and lowers the saw became rusted in the support column that houses it. After a lot of not so gentle persuasion it was freed and lubed. Problem is that I can now not seem to slide the radial arm down onto the shaft from,the top. If I feed it from the bottom it slides in fine until you get towards the top, but once there there's not enough wiggle room to fasten the latching mechanism. Anyone here have Any experience or thoughts on this?

Thanks,

John

Re: Craftsman RAS reassembly

#2

Is it possible in the disassembly

Gary Smyth

that the tube was turned end for end and each end has a different OD? That tube is about16-18 inches in length with about six inches exposed. Silly, but have you tried to flip it?

Re: Craftsman RAS reassembly

#3

Re: Craftsman RAS reassembly

Jerry Gibbs

I have model 113.23100. Her is a pic from my manual. Jerry

Re: Craftsman RAS reassembly

#4

Re: Is it possible in the disassembly

Jpleech

Based upon the manual, I'm pretty sure that I have it oriented correctly. It's been suggested that in disassembly, the top of the tube was deformed, so the radial arm will no longer slide over the top of the column.