Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

911 call for help with fumed table

Posts

911 call for help with fumed table

#1

911 call for help with fumed table

Brad Bransky

Because of a stupid construction error (mine), I had to strip one leg of shellac and wax from a fumed 1/4 sawn white oak coffee table which was to be delivered today.

My question is, when I refume the leg, can I put the entire table in the chamber WITHOUT FURTHER FUMING the rest of the table which has four coats of both orange dewaxed (my mix) shellac and Johnson's paste floor wax ala Gustav?

Or, do I have to isolate the leg and fume only it.

I kind of think I the ammonia (12% aqueous solution) wont make it through the wax but would it make it gummy?

Brad

Re: 911 call for help with fumed table

#2

Ellis Walentine

Play it safe.

Ellis Walentine

Seems to me that ammonia fumes could affect both the wax and the shellac. To play it safe, if you can possibly tent the leg you want to fume and confine the ammonia to this enclosure, I would do that, rather than fume the entire piece. Otherwise, see if you can do a controlled test run on an inconspicuous section of the table before fuming the whole piece.

Ellis

Re: 911 call for help with fumed table

#3

Re: Play it safe.

Brad Bransky

Ellis, I'm sure you're correct and reinforce my own notions. I don't think I will be able to replicate the same darkness but I've got to give it a go. I will isolate the leg and hope to get it right. I thought about a wet application but have no idea how to stop the darkening short of rinsing the leg.

Oh well, all is not lost. The table will look good in my fly tying room. I'll just put the bad leg in the rear in front of the sofa. I'll tell the customer the table didn't meet my expectations rather than I screwed up.

Thanks,Brad

Re: 911 call for help with fumed table

#4

Testing is a must

Bill Tindall, E.Tn.

The high humidity and strong base of the fuming is likely to have some effect on the shellac. The wax will not be a significant barrier.

Fuming relies on fumes. What happens if you just brush the ammonia solution on?

Re: 911 call for help with fumed table

#5

Re: Play it safe.

Bill Tindall, E.Tn.

I think that the wet application on a test piece should be tested.

Re: 911 call for help with fumed table

#6

Re: Play it safe.

Mark Mandell - Gone Round In New Jersey

Brad,

An isolated tent is called for as the fumes will craze the shellac. However, you can take care of any color differences by adding small amounts of TransTint dye concentrate to your dewaxed shellac. I use TT and Shellac to blend wood color all the time. Doesn't take much, especially if you have an air brush or mini gun spray rig that you can dial back on the material while using a wide fan. More difficult hand applying because of lap marks.

Re: 911 call for help with fumed table

#7

Re: 911 call for help with fumed table

Brad Bransky

I isolated the leg behind clear plastic, exposed it to 29.4% aqueous ammonia fumes and it was sufficiently darkened in about 6 minutes. I gambled and won this time. Next time I follow the good advice below and test it first. Thanks for the comments and suggestions.

Brad

Re: 911 call for help with fumed table

#8

Re: 911 call for help with fumed table

Brad Bransky

"...comments and suggestions above", I should say.