Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

planer blades

Posts

planer blades

#1

planer blades

vance hough

I have a Woodmaster 712 planer/molder. I need to plow out a 1/4" of oak wood on stair treads a width of 9 1/2", i.e. a dado that is 1/4" deep and 9 1/2" wide. I have been using a tablesaw with a dado blade but the old arm gets tired after doing 30/day. I am wondering if anyone has used a wide planer blade in their 712? The blade needs to protrude out from the gibbs 1". Some treads need to be plowed out more than 1/4". Is this feasible or would the blades bend under all the pressure? I really could not get a definitive answer from Woodmaster.

Re: planer blades

#2

Re: planer blades

Dick Coers

Planer blades are pretty hard steel, probably break instead of bend. I would not over stress the cutter head that much either. That's way beyond design limitations. I would use a shaper with power feeder, or a power feeder for your table saw. At that small cut, you could use the highest speed on the feeder and throw the stock through the saw.

Re: planer blades

#3

Re: planer blades

Brad Bransky

What about slicing off the nose of the tread, plane the tread to measure then reattach the nose.

Just a thought!

Brad

Re: planer blades

#4

Bob

Router?

Bob

If your doing that much why not use ROUTER table? Doesn't WM have a set up to do a double operation like that?