Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Drawer bottoms...to glue or not?

Posts

Drawer bottoms...to glue or not?

#1

Drawer bottoms...to glue or not?

Rich Pearson in Mill Creek, WA

SWMBO has ordered a remodel of all the lower cabinets in the kitchen. All shelving is to be removed and full extension drawers constructed throughout.

1/2" thick by 4" wide maple veneered pre-finished drawer sides are ready with a standard interlocking cabinet joint. The joints are glued and will be also secured by 18 gauge brads. The orientation of the brads and joints will resist the mechanical action of pulling and pushing the drawer in/out.

The drawer bottoms are 1/2" thick pre-finished maple plywood which slide into a snug 1/4" deep dado in the drawer sides, all pretty much standard drawers.. SWMBO wanted a sturdy DRAWER!

Should I glue the bottoms to the dado?

Re: Drawer bottoms...to glue or not?

#2

Re: Drawer bottoms...to glue or not?

Dick Coers

I like to glue in plywood bottoms, but using prefinished is either going to take different glue, or you won't gain much of anything. Sizing the bottom so the raw edge touch the sides will be nearly impossible. So unless you get something that sticks to clear finish, I vote don't bother.

Re: Drawer bottoms...to glue or not?

#3

Re: Drawer bottoms...to glue or not?

Jesse Cloud

Dick pretty much nailed it. +1

Only reason to do otherwise is if you want the ability to remove and replace the bottom (say after a spill or if it cracks, warps, etc.).

Then do a more traditional drawer by making a through cut on the back where the dado would be, insert the bottom and nail or screw it to the back, voila, removeable bottom.