Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Cradle in Walnut,Walnut Veneer and Hickory

Posts

Cradle in Walnut,Walnut Veneer and Hickory

#1

Alan Young

Cradle in Walnut,Walnut Veneer and Hickory

Alan Young

Our fourth grandchild arrived a little over a week ago-But before I could finish this cradle. H-26 1/2",W-28 1/4,L-33". I searched a while for different cradle designs-then took elements I liked and came up with this design.







If I make any more I'll probably alter the width as 28 1/4 is plenty wide-my daughter likes it though because she thinks our granddaughter can be here longer. I don't recall the radius of the rockers but that will get adjusted too-It seemed to rock well in development stages but in the final edition it flattens out sooner than I would like-I may remake the rockers at some point.-Alan

Re: Cradle in Walnut,Walnut Veneer and Hickory

#2

Re: Cradle in Walnut,Walnut Veneer and Hickory

mark valsi

Nice job, I like the design !

Re: Cradle in Walnut,Walnut Veneer and Hickory

#3

Re: Cradle in Walnut,Walnut Veneer and Hickory

Larry in nw ohio

As Mark said Very good design, also good lumber picking. For our 3 children I just went right to the baby bed, they are in the shop shots. They went from simple to more and more difficult, at least for me. Larry

Re: Cradle in Walnut,Walnut Veneer and Hickory

#4

Needs a mobile

Thomas Skaggs, Foothills of Mount Level

Well, there you go, kicking out another great heirloom. Now you need to make a mobile for it...hey, just sayin' ;-)

T.

Re: Cradle in Walnut,Walnut Veneer and Hickory

#5

Very Nicely Done

Mark Mandell - Gone Round In New Jersey

Care to tell how you made the legs? Stacked? Routed? Dadoes? All of same? :D

Re: Cradle in Walnut,Walnut Veneer and Hickory

#6

BTW

Mark Mandell - Gone Round In New Jersey

Howcome the bead along to the top of only one end?

Re: Cradle in Walnut,Walnut Veneer and Hickory

#7

Alan Young

The legs

Alan Young

are 1.5" square. I cut the recessed sections on the table saw with the miter gauge. First cut the bevels with blade at 45. Then hogged out the waste sectios with a dado...

Re: Cradle in Walnut,Walnut Veneer and Hickory

#8

Alan Young

Dear Sherlock!!

Alan Young

Only noticed it myself after it was glued-I was distracted by other things during this build-Thought I had run all the grooves but I hadn't...Grandad becoming forgetful.

Re: Cradle in Walnut,Walnut Veneer and Hickory

#9

I Was Close

Mark Mandell - Gone Round In New Jersey

My guess was dado for the hogging and then a bench chisel for the bevels. ;)