Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Drilling holes in squeeze clamps

Posts

Drilling holes in squeeze clamps

#1

Drilling holes in squeeze clamps

Tom Dunlap

I want to combine two squeeze clamps by removing opposite heads and bolting the two 'rods' together.

The steel is obviously hardened because my drill bit just runs on it.

What angle should the drill bit be sharpened in order to

Drill through?

Thanks

Tom

Re: Drilling holes in squeeze clamps

#2

Re: Drilling holes in squeeze clamps

R Payne

What type of drill bit? Carbon steel, HSS, Cobalt? For drilling in steel, HSS or cobalt or similar is more important than sharpening angle.

On thing you could try is a "spot anneal". This is fairly simple (if the steel you're annealing isn't air hardening). Take a nail, cut the head off, chuck it into a drill and run it on the spot you want to drill until it heats up enough to soften that spot.

Re: Drilling holes in squeeze clamps

#3

Re: Drilling holes in squeeze clamps

John Lucas

It has to heat the spot red hot. This does work but is slow. I purchased an Artu drill bit which will drill through anything. I doesn't start drilling until the drill bit gets red hot and then it just punches right through.

Another alternative is to heat the ends of the clamps red hot and let them cool. This will soften them. If you put a heat sink such as a pair of lock nose pliers or a C clamp near the end it will absorb the heat and not a anneal any of the rest of the clamp.