Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Drill Press "extention" . . .

Posts

Drill Press "extention" . . .

#1

Drill Press "extention" . . .

Steve Mackay

One day, when I'm all grow'd up, I'll have a floor model. But for now . . .

Just clamp the fixture to the side of the bench, clamp down the DP and swing the head around. Just make sure to "plumb" the fixture in relation to the DP. The fixture only took an afternoon to build.




Re: Drill Press "extention" . . .

#2

Re: Drill Press "extention" . . .

Bruce, a MN Galoot

having just gone through an extended trial of the same nature with my benchtop DP, I applaud you on your solution. It's very clever.

I've been on the prowl for a floor model for quite some time now. I thought I had one last week, but the guy just wouldn't call back. Oh well....

Re: Drill Press "extention" . . .

#3

Good solution!

John in NM

My drill press has some sliding rings on the mast, one is clamped just under the head so that I can do exactly what you have done, without having to hold the head up while I tighten the clamp screw. Though a bench model, mine is still quite heavy.

I also often turn the table to vertical and clamp jigs to it, as you have done to the work bench. If the drill press is leveled, re-setting the table is quite easy. Mine is on wheels and a bit out of level, so I have used the level on an adjustable square, and sometimes even a dial indicator to re-set the table. The deluxe route would be to have two tables! Though perhaps the mast isn't tall enough for that.

Re: Drill Press "extention" . . .

#4

That's a great idea

Howard in Toronto

Looks very useful for those of us with the smallers drill presses.

Howard