Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Outdoors stand for statue

Posts

Outdoors stand for statue

#1

Outdoors stand for statue

Howard

I have to make a small garden stand for a small stone statue. It will not be finished and waster will get between the bench top and the bottom of the statue that will take a long time to dry out. What wood would be best for the bench?

I have ruled out teak because of the cost.

Some options suggested to me are Western red cedar, cypress and African mahogany.

Thanks

Howard

Re: Outdoors stand for statue

#2

Re: Outdoors stand for statue

paul in AZ

White oak would be my first choice for rot resistance, followed by cypress. Oak is not expensive.

White oak with no finish on it has been used for centuries in boat construction, for good reason. If you are using nails or screws I've heard that white oak's tannins (?) or acids(?) will corrode anything other than stainless steel fasteners.

Re: Outdoors stand for statue

#3

Re: Outdoors stand for statue

Larry Clinton At Frankfort, (Central) Indiana

Probably IPE would be my first choice although on the higher priced side, it may be worth it to estimate the BF required Vs the amount of work hours and life span of the work. Another good choice of domestic wood would be Black Locust - if available in your area.

Re: Outdoors stand for statue

#4

Re: Outdoors stand for statue

Mark Mandell - Gone Round In New Jersey

A. Black Locust

B. create a small gap (1/8-3/16") between the stone and the wood surface using a non absorbing material in small blocks (stainless or HDPE for instance) to allow drying of the wood surface. Your stone will attract and grow moss/lichen/other-green-stuff so be prepared to clean it several times a year.

Re: Outdoors stand for statue

#5

Re: Outdoors stand for statue

Howard Acheson

>>>> White oak would be my first choice for rot resistance,

The problem with white oak is that while it is highly rot resistant, it will readily stain and discolor due to the minerals absorbed by rain.

I don't know how big the stand will be but if you want it to be long lived and maintain a reasonable appearance, I would seriously look at Ipe. Ipe is used for things like seaside boardwalks. In fact, the Atlantic City boardwalk was constructed with Ipe which has lasted almost 100 years. It will be more expensive than some other wood but you get what you pay for.

Re: Outdoors stand for statue

#6

Re: Outdoors stand for statue

Barry Irby

I agree with all the above except the gap should be a little larger. More than 3/8". Water will form drops under the stone and they can be as tall as 3/8 if they can cling to the upper surface.

Re: Outdoors stand for statue

#7

Atlantic City Board Walk

Barry Irby

A local dealer bought the Atlantic City Board Walk and brought it back to Chesterfield County. They are sawing about a half inch off each edge and face of the beams and then reselling the lumber. The Remainder was about ninety percent or more sound and close to 3 by 10 or maybe 12. They had tractor trailer loads of it. So, if its a hundred years old now, it may be good for another hundred.

Re: Outdoors stand for statue

#8

Re: Outdoors stand for statue

rogerincolorado

I don't know what size the statue is, but it seems to me that you should be able to find a concrete post to set a marble or granite "shelf" on to support the statue. A memorial stoneworks should be able to help. Every wood option is going to be really expensive or require maintenance or both.